Frost King RS510XB/6 Rubber Tubular Pipe Insulation, 1/2" ID x 1/2"Wall x 6 ft, Blue

Used this to replace rotting insulation on the suction pipe on a Carrier AC unit. Insulation was very flexible. I was able to secure it around a couple of bends in the pipe without cutting it using zip ties and electrical tape (Scotch 33). Made for a fairly easy job without needing a service call from AC company.The adhesive is very strong and provides a good seal for the insulation. TIP: Be sure to fit the insulation on the pipe before you remove the tape and expose the adhesive.Good product. Recommended if you need to replace your pipe insulation.

The tube was pretty easy to install (my pipes are on the ground so it was hard to get the tubing under them but that’s not the makers fault). That adhesive properties worked great but I still felt the need to tape mine because it wasn’t completely adhered in some spots.

My AC return lines were having a a crusty insulation sleeve due to the Arizona sun. It was time to have it changed.I started to remove the old sleeve then cleanup the pipe with brake cleaner and rags to make sure it was as clean as possible.I added some insulated tape first as the first insulation layer then I put this sleeve on top of it and finished the job with UV and water resistant tape.I had issues removing the film protecting the glue on the sleeve. Peeling the film pulled also the glue out for the most part on one side if not both side so you have to go slowly but it is not bullet proof.Another issue was with the elbow on the pipe. Even though the sleeve is flexible, I just couldn't have it slide properly there. So I had to cut multiple parts and plug wherever I could. This is where the tape is handy to stick everything together.The result is great though and I'm hoping I won't have to do the job anytime soon.

What impressed my about this particular brand was the glue and peel strip. That is where the other brands lack. It's one of the most important things when installing that it peels easy and stays stuck together. I recommend it over the brand big box chain stores are selling. Comes sealed in plastic and boxed for protection also.

Fit nice over A/C line and then covered with foil tape to make it perfect 👍

Used to re-insulate my AC line. Worked fine. Some of the adhesive came off with the plastic coating but enough stayed to be useful. I used HVAC line tape over the seam just to be safe.

For some reason this high density foam pipe insulation for AC lines is hard to find in the stores around here, all that is stocked is for interior use. Anyway, this came coiled/folded up in a box, but pretty much unkinked when laid out for a while. Had no problem with the adhesive edges joining and staying in place. The piece was 3" short of 6', but no problem for my project.

Insulation is fine, self sealing is bad. If I were purchasing pipe insulation again I'd go with one without adhesive and use zip ties to hold it around bends.

The rubber is rigid enough that you can remove the paper adhesive covers along the seam and seal it easily over the pipe.. Does not tear but cuts nicely when trimming. One length did 2 air conditioners since both are close to the building.

Bon matériel , ça fiter parfaitement et reçu rapidement