10,000W Hard-Wired Garage Heater – Industrial & Commercial Ceiling Mount, 240V Fan-Forced Heater with Remote, Digital Thermostat, Timer, 2 Heat Settings, Overheat Protection, Grey

Got mine installed and did not have the hinge rear to drop access to the wire hookup area. Simple install to the garage ceiling with a pilot hole for a 2" long, 1/4 in width wood hex head with nice big flat washers to support the single center attachment point to the garage ceiling. Ezy pzy and plenty secure. I wanted to be able to turn the fan direction if wanted. Ran 10 ga 2 wire with ground to it from the QUALITY dryer plug bought here at the Zon, and wired the unit. I set on heat level #2 and turned it on. Excellent HOT heat coming out, and 12 feet away the fan is clearly doing it's job. The fan power is fine, the heat is HOT just set on 2, and the only potential drawback for some is the thermostat is not as accurate in function as your whole house furnace is. Who cares? Most are using this for a garage or shop, and some don't want those to drop under freezing when unattended and unused. I set up a remote temp sensor and in a 12 x 25 ft garage, in Omaha NE and if you want to keep your garage above freezing, this unit can do that. Really, it can do that not working very hard. I was thinking this was a big toy, might help a little or might not. I was wrong. This is a serious tool, well made, works, hot heat and fan plenty strong - and all at $109? Are you kidding me?? Can see other uses for this heater, too. This is NOT a toy, works, HOT heat, good fan, makes a bit of mild fan noise but WHO CARES? You sleeping in your garage? I got the ex warranty so if this goes South I'm covered, but by any account this is a nice unit, works, built solidly and if you do your own wiring be SAFE and be SURE to use a GOOD dryer plug with a lot of surface contact to your 10 ga wire. Critical. Tight and solid good connections is important. Get your gas cans out of your garage and into the shed. Read directions and adhere to them. They're there for a reason. My garage ceiling is only 7" but I attached this as high as I could right to the ceiling joists, center factory attachment point with big flat washers to help support. VERY impressive heater at this price point!!! Nice. My only nitpick is they should have made the ground attachment point the same as the two positives, with easy secure attachment. I used the extra wide wire crimper tool to secure a yellow 10ga wire loop to the end of the ground wire, then attached that to the ground point on the unit where they supplied the hex head bolt attachment. Works fine. Just UN-necessary and their trying to maximize profit by saving a buck a copy. No bid deal. GOOD UNIT. PS: The Zon 10 ga 2 wire and one ground wire pricing was way better than the big store big name hardware stores here!!

I live in a house about the size of a 2 car garage. My gas furnace went out and this was supposed to be a temporary replacement to keep us warm. Scratch that temporary. It's heating my house better than the Gas furnace. Installation is easy, I did have to upgrade a breaker, but that's on me. Quite happy with this little heater that Can. Pretty quiet as well. Small size, and good airflow. Having a remote moperational. easy.

It would be a 5-star if I had a smaller garage; it is definitely doing its job. For a larger 3-car garage in the Midwest winter, for example, it's 14 outside, and the garage is a warm 55. I would give it five stars if it were a little quieter when it kicks on and a little more efficient thermostat. Again, I love it. If you have a 2-car like my father, who I bought one for, it's 5-star all day long. A 3-car is pushing it a little harder unless you want to run it over 65-70 in the Midwest winter.

Works perfect in Our new 3rd stall garage. We installed a 12x24 attached 3rd stall and needed a heat spruce for the midwestern winters. The heater heats up fast and is easy to install. This is perfect size and out of the way for my husband’s woodworking shop. If only it came with a remote or a swivel so you do t ha e to do it manually.

This ceiling mounted heater came packaged safely and securely. Item was new and wasn't missing anything whatsoever. The instructions were a bit vague but let's face it. If you are purchasing this heater than I assume you noticed that it say's "hard-wired" in the title, I hope. Now for any of you that don't know what that means. It means that you will have to wire this thing to your breaker panel yourself. It does not come pre-equipped with a power cord/wall plug. You will have to order or go to the store and buy the appropriate 10/2 AWG, copper, insulated and grounded wire, as well as flexible conduit, and the appropriate 30a breaker for your panel if you don't already have an empty one inside your panel that is functional and not currently being used by something else. And that is assuming that this is the method in which you plan on using. If you do not know what I am saying and this is all gibberish to you then I highly suggest you seek professional help or keep on looking for something that doesn't require you run cables through your walls/attics and mess with anything inside your breaker panel because if done incorrectly you can injure yourself quite badly. In other words. You will likely be electrocuted! And not the fun kind of electrocuted either... That is only the risk to your person directly. the next major consideration is that, if done incorrectly, you will likely cause a fire at the breaker panel or at the heater itself or even anywhere down the length of cable that you installed yourself in which was not the correct choice for a lot of you out there that don't know exactly what you are doing in regards to electrical installation of a high voltage appliance such as this heater. So, long story short. Please do your research and make sure you know what you are getting into, what is required of you, and what the risks are if you decide to take this on yourself without any training or professional supervision. Please be safe and be smart. This heater kicks A$$ though in every way! Take care and stay crispy... ;p

Unit is quiet and with 7.2 KW it puts out great heat . For The price its a good unit

Installed the heater in my 500sqft garage with R12 insulation and it works great. I think it could be better if I bent the fan blades a bit more to increase air movement but honestly, it is just fine. I use an additional fan mounted up by the ceiling to circulate more air and it helps get the heat off of the ceiling. I connected my heater to a 2 pole 30A switch so I do not need to access the controls and it works like a charm. Highly recommended.

apres 3 semaines utilisation le radiateur donnait un rendement satisfaisant mais il fait un bruit moteur que je suis obliger arreter .

Still toying with it but so far the thermostat switch does not seem sensitive enough to hold a steady temp. I have used this heater for a while now and I am very satisfied with the performance. I switch it on the middle setting for about an hour before going into the shop/garage and can expect 12-15 degrees on a cool west coast (6-7 degree) day. I necessary I'm sure I would be able to satisfactorily heat the 400' space in much colder weather.

This works so well. Easy to use. And like the remote. Would be nice if connected to wifi