Plasma Cutter with Large LED Display, [Non-Touch Pilot Arc] [Air Sensor] hynade 55A Plasma Cutter Machine 110/220V Dual Voltage, IGBT Inverter, 1/2'' Clean Cut, 2T/4T for Beginners DIY(User Manual)

This plasma cutter works great out of the box and is perfect for a beginner. For the price, do I expect it to last the long haul? Absolutely not, but it's perfect for something you'll only use occasionally. I think it's safe to assume all of these cheaper units are going to functionally work the same, so really what it came down to for me was that it has a 'non-touch pilot arc, the air hose fitting was a standard NPT connection, and it incorporated a drying filter. So far, I've only cut 3/8" sheet with it, and to be honest, that was my first experience with using a plasma cutter. That said...it took 3 minutes to set up, I plugged it in (220), turned my air on (20-year-old Craftsman 30-gal), put on some safety glasses, pulled the trigger, and it cut like butter. Couldn't have been any easier!

As long as you have the right expectations, this is a very nice plasma cutter for a great price. With 240V, this cutter can handle some seriously thick steel. My original thinking was running for some of my stuff on a standard 120V 20A circuit for convenience. That was...shall we say...disappointing. You really need 30A or higher for both 240V and 120V. If you have that, you'll love this. If you were hoping to run this on standard 120V 20A garage outlets, look for something else. It is much smaller and lighter than I expected and seems well built. I had no issues setting it up and it's super easy to use. I expect to be using this for a long time. Now I'm always looking for opportunities to cut something up.

Great plasma cutter. The functionality is very good and straightforward. I’ve used it on a maximum 3mm metal and it works as expected. Even when I missed the ground clamp connection it made some cut with the pilot arc. The turning of the air, post flow and current settings is very easy and clear. Works great with 220v power grid.

Cuts pretty good. Only cut 3/16” plate but it work good. Only use the hyanade brand consumables I tried another brand and it started to cut poorly, they come loose on their own. The grounding clamp is very fragile so plan to change that out. Pretty easy to use. I always had it set at 50 amps and 55 psi. No air leaks. Has a few little cons but it is well worth the money

Works wonderful. Used 220v have not tried 110v yet. Well worth the money.

This is my first plasma cutter and I was very surprised at how well it worked and how many great features it has. It saves so much time versus oxy- acetylene cutting or cut off disks. Even having no expertise using it, I got very acceptable results from the first use.

Good cutter for the price

Defective on arrival. Power flashes off as soon as you pull the trigger. No stars given

Perfect for what I uses it for

Works pretty good if you’re looking for an affordable plasma cutter.

The price was right and it cuts metal like a hot knife through butter. I hope it has some longevity.

My husband loves it.

Bon achat mon conjoint et mon fils sont très satisfait