Whiteside 2292 Chamfer Router Bit: 45 Degree Angle, 1/4 Inch Shank, 7/16 Inch Cutting Length, 5/16 Inch Cutting Height

So far I've only used this on two projects, so I can't comment on longevity. However the cut quality is excellent and the bit is very well machined. I've purchased a few of these Whiteside router bits at this point and they seem to be as good as everyone says. Recommended.

Like all of my other Whiteside bits, this one is excellent. Highly recommend.

I have owned other brands of router bits but Whiteside bits are the best I have used. I use this chamfer bit to make miter joints and the 45 deg. angle is dead on accurate.

Just works well

All of my Whiteside bits cut smoothly and last longer than my Freud bits

Happy with that purchase, makes it easy to put small bezels on my wood pieces

I uses this bit to put a chamfer on my cutting board edges. Bit cuts very smooth and leaves a clean edge that only needs a light sanding. Does well through any wood from pine to maple with no burning or blow out.

Whiteside always well made. Yes I think you pay a premium, so buy once. cry once. Made in the USA.