G1/4" 10K Temperature Sensor Stop Fitting, Black

Works great. Quality is okay.

Works great with my Corsair Core XT hub. Just plugged it in and it started reading temperatures.

I only paid about $14, I wasn't expecting that much. However, it does exactly what I want it to. It transmits the temperature of my reservoir to my motherboard so I can make sure my coolant stays where it should be. I have fan controls tied to the coolant temperature, so I need that temperature to be fairly accurate. However, I do get random/occasional spikes where the coolant temp will shoot from 29 degrees up to 100 degrees, and then go right back to where it should be. The spike lasts only for one polling period. However, that is enough to make my fans start speeding up, so it interrupts an otherwise silent PC. If this isn't an issue for you, I say absolutely buy this sensor for the cheap piece of mind it gives you.

Works as it should. Doesn't leak and temps are accurate.

The sensor that comes with the corsair pump sticks out to much for my liking. This one can be put in different spots of my loop without losing any flow.

Gives an accurate temperature reading, or seemingly. Easy to install, cable is long enough. Recently added a new card to my loop, pressure tested and everything was fine, but noticed the plug developed a small dripping leak after only about a month or so. Put some sealant over the wire/hole leading out of the plug, will see if this holds up. Gave two stars because yeah it works for a little while, then seems to just fail. Going to have to wait to drain my loop and see if the sealant worked. Would imagine barrow could add some sort of better sealant to the plug, or something else to prevent the small leak.

For the price, this is the best thing i've put in my computer since i built it 4 years ago. If your Mobo has a temp sensor header, you need this. I control all of my fans based on coolant temp and nothing I have in the loop even gets hot. It's silent until everything gets good and warmed up for the long haul. The fans do not ramp up for and endless, pointless reasoning of time. I have them set to run wide open when the coolant temp hits 45C and it's never happened yet. Any game i have that pushes my XFX 6900xt hasn't made the water temp go over 42C, leaving the GPU hot spot temp at ~90C. This switch is an epic win in my book.

Have this probe mounted on a flow sensor block coming off the GPU to measure heat gain after graphics card and so far it works as expected and reads accurately. I have a laser temperature sensor and double check temp sensors periodically and this has been right on since it was installed about 60 days ago.

Built an EKWB loop and this is the only non-EKWB component. Connected to my EK G1 distro plate. Not sure if the temp is perfectly accurate (I get around 23 degrees reported in AI Suite III when the system is idling) but it doesn't really matter as you can just set your fan curves to accommodate the relative reading to achieve your desired fan behaviour regardless.

Produit qui m'a coûté cher par rapport à ce qu'on peut trouver en boutique spécialisée mais j'en avais besoin rapidement. Branché sur une Asus RoG pour monitorer la température du circuit GPU custom

Funziona perfettamente su una Asus Prime B550-Plus. Fondamentale per controllare bene le ventole se si ha una CPU che scalda poco ma una GPU che scalda molto.

Die Dichtung ist relativ dick, was erlaubt das Teil immer dicht zu kriegen.

arrivato prima del previsto ,imballo perfetto prodotto ottimo!!!