Copper Tubing Cutter 1/8" to 1-1/8"

I use these for alloy handlebars and steerer tubes on forks. Really good, clean cut. The reamer is a nice freebie.

I found this pipe cutter easy to use, easy to position accurately and its compact design allows it to be used in confined spaces. I needed to cut into an existing 28mm primary circuit in copper and this tool was perfect for the job. The cutting wheel is firmly located allowing no lateral movement, and the opposed supporting bearings are in a broad housing and rotate freely and smoothly. It's only a pipe cutter, but the design and engineering of it has been given careful and effective thought. The deburring tool it comes with works very well too.

I've not used this a great deal as plumbing isn't my primary trade but I'm currently lending a hand to a heating engineer.Deals with 42, 54 and 67mm copper flawlessly for a great deal cheaper than a rothenburg or similar branded equivalent.There is no quick slide action that some cutters have but the adjustment wheel.spins freely and adjustment really doesn't take long at all.I won't guess at reliability but so far so good.

It did amazing job by cutting 5mm thick wall of a pipe and it is suitable for all different types of metal pipe to do the job and accuracy and fit.

I thought that this pipe cutter looked a bit ‘plastic’ but when it arrived I was pleasantly surprised at how weighty it is. I needed it to cut through a 32mm steel hanging rail which it did with ease. I’m not sure about the de-burring tool because I didn’t try to use it (I didn’t need to), but I would recommend this tool if you need a large diameter metal pipe cutter.

I have a couple of other pipe cutters for 15 and 22 mm copper pipe but needed something bigger to cut some alloy tube.This is a great tool and the burr removing tool, much loved by engineers, is really useful to finish sharp edges.Unlike some cheaper units, this goes cut straight and true - so doesn't wander off line.The silicon rubber twist grip isn't very tight so you need to give it some grip to stop it slipping. However, this is is a minor fault on an otherwise well made tool.

They did exactly what I expected them to do.Great for straight cuts on conduit

Absolute garbage, while cutting an aluminium bicycle fork steer tube the blade walked from side to side and created a raised, swollen outer area which need to be sanded down. The debur tool is nice for the internal tube cleaning.