KBH Auto Door Panel Armrest Cover for Honda Odyssey 2011-2017 Vinyl Microfiber Leather Car Door Armrest Replacement Pair Dark Gray

Overall this is a good product. It takes some patience to wrap the panel nicely, but the finished product looks almost factory. The vinyl is stretchable and easy to work with. The color match isn't perfect, but good enough. Buy some good spray adhesive to make the wrapping easier.

اللون مختلف

Not an easy installation but once it was done, made the interior of the car look much better.

There are two things that keep this item from being perfect. First it has contrast stitching so you need to replace them in pairs or they will be different. I initially intended to replace only the drivers side since it takes all the abuse and was falling apart. The second thing is that the factory cover has a plastic piece at the stitching and it helps you line up the panel with the plastic door piece it attaches to. If that piece was included it would have taken away the need to eyeball the cover and make sure you have it lined up correctly. It is simple to put the seam in the plastic groove but the tabs help line it up left and right if that makes sense. Overall seems like it will be a good product. Just installed it so no idea how it will wear but it seems solid. I bought the can of Permatex headliner adhesive that others recommended and it seemed perfect for this job. Check the Youtube videos for detailed instructions on door/panel removal. There are great videos that show where the 4 screws are located on the door.

I thought the quality and color match of this was very good - good value. I have four installation pointers: (1) I removed the plastic guide strip from the OEM pad to aid initial alignment. Just remove stitches and glue to the replacement along the seam. (2) Contact cement doesn't work ... I thought that is what they were using in the installation video. Regardless, I found 3M Super 77 spray adhesive to work perfectly - it holds the fabric, and is easy to pull back if a mistake is made. (3) The curve in the middle is a struggle to get adhesion with smoothness (OEM uses a vacuum system), but I found that by using a 1-1/2" rigid foam cylinder worked great to press into that curve. (4) The plastic tool that is included is useless. Stretching the fabric is all that is needed to remove creases and get an OEM look. Along the edge, I used pliers to pull, and then press with my fingers on the back side.