elechawk 1.25mm Pitch Connectors and Pre-crimped Silicone Cables Compatible with Molex PicoBlade for Pixhawk 2.4.8 15cm Wire

Works well for RunCam Thumb Pro W to Speedybee BEC. Speedybee say "SH1.25 4P" and some places say "JST1.25" but it seems the correct naming is MX1.25 or Molex Picoblade.

If you plug the wires into 2 x connectors to form a new cable and later decide that you want to reuse the 2 x connectors and break down your cable into it's parts again, it is easy. Hold onto the white connector piece firmly and with your other hand take just one of your plugged in wires and give it a sharp, hard pull. This will remove the wire from the connector easily, but will break the crimp lug on your wire during removal. But this is fine as you have many such wires at your disposal, and much much less white connector parts. So if you make a mistake in your cable assembly, or simply want to reuse a connector - you know what to do now. BTW: The tweezers are stored in the wires compartment. For me, I needed to dig out the whole bunch of wires and find the tweezers buried in that wire bunch. So, the tweezers are included!

Gute passform, sauber gecrimpte Kabel. Top Set!

Good

Super organized little package, lots of options, everything fits nice and is of great quality. Highly recommended.

Belli i fili siliconici, molto robusti e flessibili

I needed only a couple of the sizes, but these will come in handy for my mini PC, which uses the 2-pin connector for its CMOS backup battery header, and the 4-pin for a secondary fan header. The silicone insulated wires are a good length (about 5 inches), and they even include some small heat-shrink tubes to cover your connections. This is a great kit if you need these parts.