Decal Mods Rubicon Hood Decals Stickers fits Jeep Wrangler Rubicon JK (2007-2018) or TJ (1997-2006) Set of 2 [Metallic Silver] SJ4T6

Perfect decals

Super easy to apply, but make sure you get it exactly where you want it, because it's not going to come back off! The adhesive is super sticky. To install it, just peel off whatever's left of the old lettering. You can gently heat the old letters with a heat gun if necessary. In my case, the sun had pretty much already done that for me. Next, you'll need a microfiber towel and some rubbing alcohol to remove the rest of the residue with the towel or hard plastic scraper. If that process is too slow for you, acetone worked better for me and didn't harm my factory paint job at all... YMMV. Line up the decal where you want it without peeling the backing or front paper off, and mark where the edges and corners should be. Next, peel of a portion of the backing from one end. Make sure you've got it straight and gently press it down. Peel the backing off as you go. Then, just peel the front paper off. If you end up getting a tiny wrinkle in one letter, press the edge of your thumbnail in the center of it, and "squeegee" it to the edge; then do the same to the other half of the wrinkle, and it'll disappear completely. If you have a bigger wrinkle, you've got a problem!

I have purchased decals from other vendors in the past and found questionable materials and quality, not so with these, they are factory look, heavy duty and for me, a perfect color match for my after market Wrangler wheels. I would recommend this seller and their product and would absolutely buy from them again.

Great product and easy to install. Looks great.

Just like new! Quantity says 1 with 2 needed however the package has two decals in it so I wound up with 2 extras.

Got these to replace my worn out rubicon logos on my 2010 Wrangler Jk. They were a direct replacement and look like factory originals.

The decals were exactly as described. It takes a little time and effort to get them lined up (you tube gas some good videos) but them went on fine once lined up. Then you try to get rid of any small bubbles in the decals. The hardest part was getting the old decals off as they had dried out and took some effort to remove. But end product looks like new Jeep.

Easy application

Good quality decal. I would recommend

The paper back would be better if it was clear it would be easier to put the sticker on straight