Whirlpool 4392065RC 29-Inch Dryer Repair Kit

SKIP aftermarket parts, definitely go with OEM. Our drier burned out the thermal fuse, and because that generally only happens if there is an underlying problem I decided to investigate. After confirming the fuse was bad I removed the front panel and drum of our drier to find one of the drum rollers chewed up pretty badly and wasn’t spinning freely. I bought this kit with new belt, tensioner, both rollers and hardware. I did completely clean both roller shafts well and added a dab of grease to the bushing on both. These rollers are not equipped with bearings, so greasing them lightly seemed logical. Took about 20 minutes to remove all old parts and install new ones, another ten minutes to reassemble the cabinet. Replaced the thermal fuse and drier fired right up and ran smoother and quieter than it has in years. After reading reviews of the many aftermarket parts I’d found there was no way I was skimping on price for an appliance that uses 220V and creates high heat- super risky. Plus I didn’t want to do this repair again in short order. So I didn’t mind spending the extra money for OEM Maytag parts, plus the fact it was a repair kit was outstanding. If you’re embarking on this repair, you’re already very deep into your drier. This is a perfect time to remove all lint, and thoroughly clean and inspect the entire unit. I checked all of the following- high and low heat cutoff switches, removed the entire exhaust box and inspected the fan and cleaned all the plumbing. Inspect your vent hose and clamps, all fasteners, and electrical connections. Our drier is 11 years old, and this is the first repair we had. We removed about $7.00 worth of loose change, various pieces of misc. hardware (not drier related), a couple buttons, a whole bunch of rogue lint, and other dirt. Most of this is extremely hazardous around heat and moving parts. All in I would definitely buy these parts again (just hoping I don’t have to), it’s so much easier and more cost effective to repair than replace an entire unit. I learned that every couple years I will be removing my front drier panel to thoroughly clean and maintain the moving parts. I’d say this is a super easy DIY repair with basic tools, and while the kit came with instructions there are plenty of videos online as well.

Perfect fit and really smooth, fits 100% on Maytag dryer. Great product

Excellent replacement part for whirlpool dryer. Squeaky? Broken belt? Loose barrel? This is what you need. Has fresh belt and the barrel wheels plug fresh clips too. Easy to replace. Directions included. This is also a factory Whirlpool part at a great price. Highly recommend.

Quality kit compared to the off brand ones. The wheels are much thicker and better. I repaired my front load dryer with this OEM kit and it runs perfect. Nice and quiet. Great price also. Would highly recommend this product. Compatibility was right on.

Only the belt is a little bit thinner than the OEM one. My customer has been using this belt for 2 years, no problem so far.