Waterproof K Type Thermocouple - Grounded Temperature Sensor Probe for PID Temperature Controller Two Wire Stainless Steel NPT3/4 BSPT 1/2 inch Pipe Thread 0~500℃ with 2m Shield Wire

good quality part

difettoso.

Simplicity of mounting

This probe works well. It did read about 2 degrees too high as compared to my other probes. However, it was consistent across the range I was interested in 0-120 deg C, so it was easily compensated for.

I was able to cut off the prongs and attach the leads to an aviation 2 prong connector without losing the function of the TC.

Make sure you check the accuracy and set it accordingly on your temp controller. Mine was reading about 4 degrees high on 2 separate controllers. A correctable problem in most controllers so not a huge issue if you only use one temp probe