Scotch Photo Mount Adhesive, 10.3oz, Safe for Color Photos, Illustrations and Pictures (6094)

Works well, great holding power. Great quality and made for photos

I purchased this so my daughter could mount her photos for her 4H county fair project and it worked great. I typically buy another name brand from a big box store but was unable to find it and took a chance with this and we have no complaints. We did lay the photo in a lid to a cardboard box to catch the overspray and it seemed to work. There was no overspray on the front of the photos, the can didn’t clog, easy to use just point and spray in a sweeping motion, it wasn’t too sticky to pick up and place on the photo mat but the photo did stick tight once in place. Highly recommend.

I used this product to mount photos onto foam board. Because of the warning on the label, I chose to use the spray outdoors rather than ventilating my entire home. It adhered the photos almost instantly with no drips, and overall, it worked very well.

I use this product to attach photographs to blank cards using textured cardstock. It works very well for this purpose. It is a bit challenging to use because the overspray can be messy. I use a cardboard mask with a hole cut to the size of the photograph, which helps. Sometimes I still get glue on the photos, but it usually wipes off with Varsol paint thinner. This product became unavailable for a long time last year and I tried other products, which weren't as good for my purpose. I live in Canada where the price for this product is unreasonable, but the U.S. price is very reasonable, so I buy from Amazon.com and get it shipped to a U.S. address.

I have been using this product for several years to mount photos sized anywhere from 8x10 to 30x36 and it is a fantastic product! But on the last can I just bought it states "CLOG-FREE DISPENSING*" but there is no corresponding text to go along with the asterisk! So is it necessary to invert the can and spray as former versions of this product stated? Also, the instructions state to line up the nozzle with the dot on the rim - but there is no dot! I'm guessing that this one slipped through Quality Control.

I’m a professional photographer who uses this to mount photos on mat board, foamcore, and even chipboard. Easy to use and good adhesion. Overspray is not bad and the smell is less than others I’ve used. An excellent product

Used to hang LEDs and fake clouds in my kids room, holds up well.

I purchased this to mount a couple of 20x30 prints to mat board. Each of them were different materials with one of them a paper based mat and the other a foam board with a smooth hard surface. I followed the instructions with mounting the 1st one to the paper based mat after 1 minute and I really couldn't rearrange it without concern over damaging the photo. Luckily the placement was close enough. Mounting to the foam board didn't present replacement issues like the 1st one and was able to lift and rearrange the placement. Moral of the story is I found it's best to start placement of the photo immediately after spraying the surface and try to get it right 1st. The adhesive seems very strong and overall works great.

A quality product that works well if directions are followed closely; use only in well-ventilated area (preferably outside).

Use if for photos.

Very good spray adhesive for photographers to mount their prints.

Looked like it would hold the picture but then started to lift. Not sure what went wrong. I had it weighted for a day.