Telecaster Chrome Bridge w/Compensated Brass Saddles & Cut-Down Sides for Fender Tele Guitar

This bridge does the job. Installed nicely with the supplied hardware. Intonated well with the included Allen key. It metal is on the thin side compared to other tele bridges I have used, but it does not seem to be a negative thing on my guitar. Ended up sounding excellent with plenty of sustain.

Solid quality, very much as expected, or better than expected (for inexpensive PRC parts). No complaints from this owner of 30+ guitars, 2 of which are kit teles, and most of which are DIY modded.

The new bridge fits my guitar perfectly. Now my intonation is much closer to perfect, without sacrificing the vintage look. I use D'addario NYXL 10-46 strings, for intonation reference; the two outer saddles tune just about perfectly, and the middle saddle nearly perfect. Now I can play up the neck without cringing. I also like this bridge's cut-down sides. Substantial metal, not cheapo, smooth chrome plating.

The sheet metal that these were pressed from is on the thin side compared to Gotoh and some others, but this is not to say this is a 'bad' thing. It seems to be 17 gauge (approx .056" or 1.43 mm) with chrome plated (which looks good). Nice brass saddles and the screws seem adequate. Updated review- I have used this on two hand made tele style guitars and feel that this is a good bridge for the money. In my initial review I viewed the sheet metal thickness as a negative but there isn't any real evidence to prove this. It intonates well due to the angles of the saddles and it's easy to space the strings where you want them and the stay put. Like the original design, you can match the string height precisely to the finger board radius. All of the questions that I have received about this product have been, "will this fit XXXX model of squier, fender, etc. I don't know but the only way to be sure is to check the measurements of your project guitar with the measurements of the product before you but it.

Fit perfect on my Squier Paranormal Nashville Stratocaster. Everything lined up perfect, no mods to install.

Looks really good. Can't wait to get it mounted on the build. Quality was nice. No complaint, as of yet.

The bridge plate is fine. The bridge saddles are not. They have very sharp Edges on them that will break your strings when you try to tune your guitar. I had to take a small file and round them over to prevent them from damaging the guitar strings. I'm going to replace them with better ones.

This is a great change to the stock dishpan Tele bridge. Direct fit for 50's style Telecaster. Very good quality and a great price

It’s a really good bridge, no need to spend a couple hundred dollars on an official one. This is a great bridge, I personally use three types of saddles for each of my teles, the saddles you get with this bridge are quality

The actual bridge is nice, the sides are cut away to not skin knuckles and the saddles are compensated. The bridge was shipped with the saddles in and the set screws down. In shipping the screws scratched the plate up a lot. I haven’t installed so I’m unsure if it will be visible or not. The seller really should at least back off the set screws.

Bridge is fine, but it doesn’t have the cut-down sides