2 Gauge Display Set - UEGO WideBand A/F Ratio Gauge (30-4110) + Boost Pressure Gauge (30-4406)

So these things worked out perfectly , I heard from many that the A/F meter breaks on the sensor side hope mines last for quite some time , my mec did a great job installing it , its fashionable and clean , reads perfectly , turns out my car has been running rich time to tune

2 years later and still working. The wideband is like all others it only gives a rough estimate. Its off a little according to my dyno tuner. id recommend these they are pretty nice.

This is an awesome set and works great but I’ve had 2 of these now and both of them the wide band sensors didn’t last long at all before failing and needing replaced. My last one I bought replacement type sensor not original and it Lasted a very long time up until atleast i got rid of the car.

The set lacks a few wiring components you'll need for any installation, but they work great so far. You'll need something to tie in your power for each, which I'd recommend minifuse add-a-circuits, a ground terminal, and an analog cable (firewire) if it applies to you for datalogging. Install was a breeze, but I wish the boost harness had been longer. The wideband harness could stretch halfway to China but the boost sensor harness fell short of where I wanted to put it.

02s is junk stopped reading almost immediately. Was just pegged at full lean

I love them. Very easy to setup and with these stealth gauge pods the people I race won’t even know what’s coming for them lol .

Awesome gauges. Very easy to read in the daytime. Only issue I had was that my boost gauge reads 2-3 psi higher than what is seen on my tuners computer. It maybe because of the t hose it comes with.

Some of the most accurate gauges on the market.