3 Piece T Handle Tap Wrench Set with Jaw Opening 1/16"-5/32", 5/32"-1/4", 1/4"-1/2" - Precise Tightening Wrenches Jaws Grip for Taps, Reamers, Screw Extractors, Drills - Made in India

Not super high quality, but I needed a tap wrench to hold a 4/40 tap. Did the job for me.

These tap wrenches appear to be of high quality.

Like others have stated, the knurling on these is useless, arguably worse than useless. You'll need a set of pliers or something to really grip the handle to actually use these. These work GREAT with taps, square ones can sit in the jaw so the corners fit between the jaws, and it doesn't need to be tightened that much to effectively stop the tap from spinning. You have to tighten it a bit more to work well with round drill bits, but it can work. I kind of appreciate it not having extreme grip on round bits, as it acts as a bit of a clutch, which is nice for drilling into soft materials. The price is pretty good, but I mostly use the smaller of the two for m2.5-m6 taps.

Works great

Well these are inexpensive and you get what you pay for. The Good is there are three sizes for the price and they do hold taps which is what they are intended for. The Bad is the machining is poor becasue they probably crank out untold thousands of these per day, but the poor workmanship makes for very difficult tightening especially when you need to close them to the smallest diameter. The poor machining makes it very difficult to untighten. There are a lot of metal spurs and rough surfaces due to the cheap price. The chuck is poorly designed in that there are two "rings" of knurling which you must have to grip them. But the rings of knurling are indented so it makes them practically useless for gripping. The knurling needs to cover the entire surface of the chuck - not just two rings indented. The Ugly? It took me about an hour of my own time to work the metal and finishing such that they would work as well as possible. Buyer beware ...

This product is a fantastic find! It's reasonably priced, making it accessible for most budgets without compromising on quality. The product is exactly as described, and its usefulness cannot be overstated. I've found it to be incredibly practical and efficient in meeting my needs. The attention to detail is impressive, and the performance is on par with more expensive alternatives. If you're looking for something reliable, well-made, and at a fair price point, this is the perfect choice. Highly recommended!

Junk. I knew these would not be high quality, but they are just about worthless. Very hard to make work right. Very hard to make hold the tap and will not stay tight on tap. A waste of money, and waste of time even if free.

Came in super handy when I needed to tap computer chassis for an odd motherboard config.