Electrically Conductive Wire Glue

Worked great. Made my project a lot easier and safer than trying to spot solder a thin wire to a metal tab. Dries fairly quick and maintained a good conductive connection. Saved me from throwing out a solar light. Highly recommend.

I'm using this product to glue a magnet onto a 21700 battery to extend the length of a third-party battery so it fits properly in my Fenix flashlight. The wire glue doesn't bond the magnet and battery that well, so I added a little bit of clear non-expensive gorilla glue and mixed it with the wire glue. This combination works extremely well. It is also very conductive.

Doesn't conduct. There's some tiny amount of conductivity when wet, nothing when dry. Surfaces were sanded clean to make good contact. When dry it flakes off with very minor effort. Mixed the whole container twice before use. Would give zero stars if possible.

Glue is probably the wrong word for this product. I was able to use it to "glue" a component back on and it did conduct electricity. I tried "glueing" a wire to a pad and couldn't get it to hold. Glue is thin and doesn't stick well. It seems to work well in limited applications. The advice in the instructions dto back this up with super glue should probably be followed.

This wire glue works, was pretty easy to mix and apply and does in fact conduct current between wires; however, it is extremely runny and does not dry quickly. I suggest applying it thinly, then layer over top with super glue unless you want to hold it for hours.

I have a group of 6, 12V outdoor lighting group of lights that enhance our front gardens around our house. On one of the light connections, one of the two wires pulled out of the plastic housing (the electrical connection was down a small hole in the plastic housing. The wire had just pulled out exposing the metal strands of wire. When I pushed the wire back into the hole, the light lit up again, but the wire would not stay inside of the hole. I knew it needed to be soldered....somehow, but with no exposure to the connecting point inside of the plastic housing it was impossible. After a bit of googling and YouTubing, I found this product which was highly recommended. I searched on Amazon, found it, ordered it, it came quickly. I put some of the wire glue on the wires and dropped a bunch down the hole, jammed the wire into the hole (the light came on), I held the wires in place for a few minutes, and after a few months of various weather (warm, wet, cold, etc) the light still works. Great product!

This stuff does work. I fixed a model train wire with it, and it works just fine, after I got it right (the third attempt). First, you have to mix the hell out of it. Not just a "shake" or a "stir." You need to dredge up the "goop" at the bottom of the jar and mix it thoroughly. It takes a while, it's not easy and when you think you're done mixing, you're not, do it for another 5 minutes (that was my first failure, not mixing enough). Then when you do use the glue, make sure your connections are super clean and make sure they are touching each other firmly prior to applying the glue. For my train fix, I had to tape it all firmly in place first. Then when you apply the glue, LESS IS MORE. You only want the bare minimum to hold it in place and make the connection. After getting it mixed right, on my second attempt I used a lot of glue thinking it would hold and connect better. Instead it just sucked up the current and created resistance. Finally, on my third attempt, I just used the tiniest of drops. Once it was fully cured sealed it with super glue and it worked perfectly. So if you do it right, learn from my mistakes, it works very well and very easy. I now have a working train.

Didn't really work. I found it too water like with no initial stick to connect a wire.