Eastwood Internal Frame Coating Aerosol | Internal chassiss Frame Rust Remover | Rust Converter and Prevention Aerosol Spray Undercoating for Vehicles |14 Oz, Black

coats very well. The 360 spray wand makes sure that everything gets coated inside . Dries very fast to , just be careful not to be under a pinch weld when applying .It fines any gap and tends to drip . Other than that it works great . easy to use .

Great product that works precisely as advertised. Used it on the internal frame rails of a Jeep JKU. Use this in open air or an extremely well ventilated area!! Very potent fumes!

Great product.

The product works as intended. Good coverage and reach with the plastic hose. Allowed me to reach entire length of 5’ GM a body doors

The tube by itself has no support so it flails all over and doesn't get paint where you want it. Straighten a clothes hanger and tape it to the tube and you'll be able to control where the paint ends up better. This system with the tube works well, it has 4 nozzles at the end the paint is expelled from. I do wish it had 6 or 8 so it got a more consistent coverage inside. You end up having to just take more passes rotating a bit each time when you can. The paint comes out with okay pressure when it gets to the nozzles in the end, I do wish it was a little stronger. You're limited however because the nozzles can only let so much out and there is a residual amount of pressure left in the tube after you let off the can nozzle, you will see what I mean when you try it. It causes it to spray 3-4 seconds longer than you're pressing the nozzle. Make sure you are wearing a respirator and goggles at the least, I even had a face shield on as well. The last thing you want is the tube to get away from you while you're spraying! You'll be telling a funny story for a good week if it does because this stuff sticks as well to skin if not better than metal. (Don't ask how I know!) Overall I feel like this did a good job and I'd recommend it to any DIY vehicle rust restoration. For reference I used 3 cans to do the back half of a boxed in 2013 Chevy 2500 frame and was able to cover everything well, see pics.

This stuff is great! The extended tip with multi-directional nozzle is perfect for spraying coating into confined spaces. Easy to use, covers well.

This is the best thing for getting into inclosed places on your truck frame or rocker panel. Very runny, it can be messy, got spots on the driveway to prove it . That's my fault, my wife is going to kill me. Will be purchasing more to do our other truck. Watch YouTube videos to see how to use it.

This stuff looks good. Only time will tell if it holds up. Have a 69 land rover that I am doing a frame off refresh. Anyone who knows rovers will admit the frames rot out. If yours is gone...you can purchase a new frame that has been galvanized dipped to fix this problem...but what can be done if your frame is original, not rotted out and you would like to keep it that way......This looks like the best bet. I high pressure power washed my frame and blasted all the loose dirt and rust from the inside flushing water through all the holes that rover originally put in the frame. I used my borescope to look inside and make sure it was clean. I noticed that even though the fan on the end of the tube sprayed out well, gravity still coated the bottom better than the top..so.. I turned the frame upside down first and gave everything a good coat. Then I turned it over right side up and coated it again. Now when I look inside the frame is coated nicely all around, top and bottom. Like I said only time will tell how well it lasts...will it be better than galvanized? I don't know but it is better than nothing inside.....and cheaper than buying a new frame if you don't kneed it.