1500035-WW

The light is nice and lit the hallway much nicer than my old fixture which burnt out those small global bulbs every month. There are a few things to care for when installing. It took about 10 minutes from start to finish, and I offer these steps to help you do so too. 1. Have a separate light source so you can see what you are doing. 2. Make sure there is at least 4 inches of source black/white wiring to be able to work it in place 3. Do not use the 3 felt feet as it puts a space between the fixture and the ceiling and it wont catch the bracket. I removed the old fixture and pulled the black/white wires out as long as possible. I removed the wire cover from the new light, and the mounting plate too I then used the 2 screws that provided to attach the plate to the existing mounting bracket inside the existing fixture. Make sure the new bracket sits flush to the ceiling and doesn't creep into the hole, else the flanges do not stick out enough and won't catch on the light. I attached the new bracket and stuck the wires into the holes (Black = L, white = N). I gave them a tug to be sure they wont come out. ** While now hanging from the ceiling I tested the light. I then put the wire cover back on. I had to use a stubby screw driver since you have very little room to work, but it only took 10 turns or so to get it in. ** Once it's screwed on test the light again!!! Sometimes the wire may come out if you didn't push it in hard enough. Then I lifted the light over one of the bracket clips (I suggest the one that is "closest" to the ceiling hole). If the light cannot "catch" the first clip, then you need to loosen the screw a few turns to allow the bracket to be less flush to the ceiling. Once I got the bracket under one of the clips , I pulled the metal "bracket release" and lifted the other end of the light and push it against the ceiling with some force to ensure it's flat. I then let the catch release go and it grabbed the light... took a few times. The light was then holding nicely and I was done. People complain about the battery cover being hard to put back on. If the wire out of the ceiling is too short then simply put a longer dongle/wire and you should be fine. People also complain about the light not being able to grab the bracket... you cannot use the felt feet and you may have to not tighten the bracket too hard against the ceiling. All in all it took just some care and an extra try or two to get it mounted. A little more effort but for the price it was worth it.

I purchased this for use on a home project and the ease of installation paid for itself. The functionality was what I was hoping for. Really brightened up the area. I will be using this seller in the future.

I like this light. I'm happy with the look, the form factor, and the twist-on, flush ceiling mount. It gives off a bright white light, perfect for a big kitchen. NOTES: Some might find it too bright for a small area, unless they are looking to do detail work and need a lot of white, "daylight" light. We have a large kitchen and we like it bright. This light fixture replaced an aging overhead light with two round fluorescent bulbs (one large 12 inch, combined with one small 8 inch). Also, I knew this new fixture might not match our old fixture's "footprint" on our kitchen ceiling so I had no worries about that, but some might not be happy if a 13 inch fixture does not cover their old fixture's opening, etc. It may mean drywall work, spackling and painting. The mounting plate and hardware were all in the package, and the mounting plate had a LOT of mounting options, so it was easy to match up with a standard U.S. electrical box (your experience may vary). Once the mounting plate is installed, the fixture is easily screwed onto the mounting plate. Having said that, you need to have some electrical and/or home renovation experience to install a product like this because it does not and should not plug in to an outlet. You have to hard-wire it, which means getting an electrician to install it or installing it yourself (not everyone is up for that). Finally, the install instructions are a bit thin. Biggest item not mentioned: since the light fixture itself twists onto the mounting plate, there is no room for wires below the mounting plate. Plan to use an electrical box, so you don't just stuff your wiring connections up into the ceiling to make everything fit flush.

Would and will buy again. Great light for bathroom. Good quality and bright.

These fixtures spread the light out better than similar products which only illuminate the area directly below the fixture. The frosted light cover directs light down as well as to the sides, so you don’t end up with a spotlight effect. The only negative is the installation procedure. If you have short electrical wires coming out of your ceiling electrical box you may find it difficult to insert the wires into the fixture. Instead of having wire leads coming out of the fixture, these fixtures require you to insert the existing wires into the fixture’s wire clips which is difficult if you don’t have long leads. To rectify the situation I inserted my own electrical wires into the fixture and used wire nuts to secure them to the electrical box wires. One other tip is to be sure to take a picture of the mounting bracket before you remove it from the fixture to begin installation. Pay attention to which way the bracket needs to face. If you accidentally attach the bracket upside down, which I did at first, it will make it very difficult to snap the fixture into the mounting bracket.

Light weight and bright enough for my toilet.

Vlotte levering en zeer eenvoudig te plaatsen. Mooi resultaat. Zeer tevreden.

very easy to install, very bright, customizable and easy to use.

mooie lamp en veel licht

Es ligero e ilumina muchisimo. Viene con todo lo necesario para poder instalarlo. Si tienes agujeros anteriores, es posible que puedas aprovecharlos, se monta con un sistema que te da un cierto juego para adaptarte, aunque no ha sido mi caso y he tenido que hacer un agujero más. El sistema de acople de los cable electricos es muy sencillo, siempre que dispongas de cierta longitud de cable en el techo para trabajar. Tampoco ha sido mi caso y he tenido que añadir un cable extra. Muy trabajoso para una sola persona que ha de aguantar el plafón mientras hace las conexiones. Salvado todo esto, es una maravilla e ilumina de lujo. Esperamos que dure lo que indica el fabricante.