TF30RCP • Weatherproof Fused AC Disconnect Switch • AC Disconnect 30A 240V • 1 Phase N3R • Horsepower Rated • 10kAIC

ge brand box and says "fusible" meaning it can be fused if necessary. This does not come with any fuse parts and is easily wired as a non fused box which was perfect for my needs.

I use this product on a mini split on a second level in a townhouse. It worked seamlessly without any issues. The instructions were a bit blurry so I had to take a picture to zoom in to understand it better I also have to watch a few YouTube videos to understand the difference between load lines and Lines to know where power from the panel and the line from the mini split unit should actually go I highly recommend that you do that as well too or hire a professional electrician. Make sure to caulk around the disconnect box well to prevent debris and water from seeping in. The one thing that I had trouble with is basically buying compatible fuses with it some of the comments that you’ll find online or confusing because for example this unit is rated up to 30 A and some comments would say you have to buy 30 fuses which is incorrect you can buy fuses up to 30 A and the goal is to match it with your unit Power consumption for example my mini split is rated for a max amperage of 20 so I installed fuses in the disconnect box rated to 20 A.

Necessary for mini-split installation. I probably could have purchased the non-fused version because I am powering my mini-split with a dedicated 30-amp breaker, but it just adds another level of protection. FYI ... cartridge fuses not included, sold separately.

Worst disconnect box I have ever installed in my 25+ years of electrical install. Bought for a mini split. Hooked the entire thing up for nothing to happen. After some investigation the disconnect had no bridge built in so of course it would never send power from the line to load side. On top of everything simply removing and re installing the pull bus once caused it to begin falling apart. Bypassed the box and everything works fine. I will never buy a box from these sellers again.

Works great

I was looking for a reasonably priced power disconnect for a mini-split I was installing. I specifically wanted a fused disconnect versus a non-fused for the ability to use a larger breaker and wire gauge for future upgrades. The install was very straightforward after securing it to my exterior wall. I bought slow-blow fuses. One thing I noticed, this disconnect is smaller compared to another brand I purchased. I actually like the look of the smaller size. As others have mentioned, be careful removing the knockouts or have some knockout reducers handy incase you make a mistake. Also, don’t forget to add a surge protector.

I like the fact that it is a fusible box but the only thing I didn’t like is that it did not come with fuses.

Pretty standard outdoor interrupt. Used this to install a mini split. Has held up to the weather no problem and works just as intended. Installation was standard and it fits standard fuses. Overall a great value over going to the hardware store.

Bonne article mais un peu chers

Didn’t know it was actually fused

Je l'ai retourné... ne fonctionne pas.

As advertised