Microjig(マイクロジグ) ゼロプレイ マイターバー テーブルソーソリアクセサリー・木工工具用 (ZP750-B2S2) 2個入り

The install and set up is a bit tricky. Drill the holes just a tiny bit out of line or accidently countersink one just a little too deep and you will have issues making the bars work smoothly. Ideally, they are easier to use as a single short miter bar such as I did on my 14 inch long taper jig. That was more than long enough to taper chair or other furniture legs. Once set up properly and dialed in, the zeroplay miter bar is dead accurate. I also like how easy it is to adjust even after it has been installed. I have four different tablesaw jigs and can move the miter bars from one jig to the other in a matter of seconds with no loss of accuracy.

Unfortunately, my saw bench mitre bar gap is 14mm. The Micro Jig width is 19mm so I was unable to use the product and subsequently returned it for a full refund. I was however very impressed with the item. The design and quality is excellent and I would recommend it for anyone requiring a solution to a sloppy fitting mitre jig of the correct width. If they had a narrower one to fit my saw bench, I would purchase it on the spot. It is a great product!

A well thought out product. I’ve made and jigs that needed good fitting runners. But you don’t have to worry about these, they will find their own fit… I’ll be buying a few more.

Me habia resultado dificil encontrar algun dispositivo que se adaptara perfectamente a las guias de mi sierra DeWalt, casi todas tienen un peque;o juego que evita que los cortes sean repetitivos y salgan con el angulo adecuado. Con esta herramienta puedo evitar ese movimiento y esta muy facil de instalar en cualquier dispositivo.

This is an excellent product which makes the building of jigs easy and very accurate.