Evan Fischer Front Engine Splash Shield Compatible with FORD ESCAPE 2013-2019, Fits LINCOLN MKC 2015-2019, Engine Under Cover

This guard fit my 2014 escape like a glove. It is much easier to deal with than the 2pc OEM shield.

Just my opinion, the OEM part was poorly constructed and the dealer wanted $150 for a replacement. Plus installation. We were pleased with replacement from Amazon. Fast delivery, good quality and apparently easy to install. (In and out in 45 minutes) I also bought the hardware package to make sure my local mechanic would have everything he needed. If you have the right equipment to DIY, It shouldn’t be that difficult. Check YouTube and save another $45.

I have mixed feelings on this. I bought it because my factory shield was damaged and hanging off and a new factory shield was over $200 and since this is plastic I figured it would hold up better than the factory version. Overall it's decent but what I don't like about it is the plastic is weak/flexible enough that it sags a little in the middle. I would have preferred a sturdier plastic with minimal sagging. It's good enough to use and still a good value for the money but if I ever have to buy another shield replacement I'll probably look at other options.

Bought this splash guard for my 2013 Escape. Works well, better that factory original. Have used it for maybe 3 or 4 years and still in great shape. Would recommend. Make sure to get tight fitting (larger diameter) screws because the Ford ones seem to get too loose over time. Can also add Loctite to the screws each time you replace them (when this is removed, such as during oil changes) to keep them from loosening as you drive, to keep this cover secured in place.

My Escape did not have a splash shield when I bought it. A very small piece of the original was stuck on a bolt meant to fasten it. Based on that piece, which seemed more of a paper based fiber, I’d say this new cover should last significantly longer if not indefinitely. It is a thick plastic and the mounting holes lined up almost perfectly. It was hard to get the first few bolts in while holding this up. Finally have peace of mind knowing the engine bay finally has protection from road debris and corrosion.

Did not fit, had to unroll it and flatten it out for several days on the garage floor and it did not line up with any of the factory mounts.

This is way better than the oem pan, soft but firm plastic instead of the flimsy fabric pan. I do recommend getting the Rexka hardware kit also for the $6.95 is worth it. Start to finish it took about 35min to install w/hardware.

Item came in and was easy to install and most of the holes were close to be accurate. However, the pictures show there is an air duct cover on it. I received the shield and there was no air duct cover. The pictures clearly show one install and riveted on the assembly. Customer service says it doesn't come with one and refunded me $10. I wanted the duct cover because it was put there for a reason. I highly don't recommend purchasing this item due to it being incomplete and deceiving pictures. Bought a different one that is COMPLETE and lower cost. Do your research folks!