GM Genuine 19209664 Liftgate Emblem, Gold

I have a 2008 Chevy HHR LT and it was difficult to identify what part to order because it is a factory defect that the outer bowtie comes discolored and will eventually fall off. Just look at HHR's in parking lots. A friend tried to repaind the plasitc outer bowtie and reglue it. I looked great for 3 days. This is official GM part. I wondered if I would have to unsrew the hex bolts underneath the tailgate/ switch mechanism. I did not want to. I was not sure how the bowtie was attached since I had already repainted/ glued it 6 months prior. Here is the deal: the bowtie/ the same that comes from Amazon, Is attached to the vehicle by adhesive. So, in order to attach new Bowtite emblem, you must remove old with out scratching paint. Notice 2 studs in picture and peel back adhesive strip. That's what there is once you need once old emblem is removed. After much discussion, I said screw it, I'm going to do take it off gently. It was a hot day, I recommend that or a hair dryer in a pinch. I took a long razor blade utility knife and carefully worked my way in between the emblem and the vehicle in a back and forth motion. Basically, you are sawing the adhesive with that long razor sharp utility knife. It took some time. Remember the 2 studs to work around finally I removed it. There was much black adhesive remaining which I remove with Goof-Off and several tack cloths. It also provided a clean surface to apply the new emblem. I lined the 2 studs to 2 holes in the body of the car, removed the adhesive protective strip and careful stuck it on, held with pressure for 2-4 minutes. It looks like new. Not bad for $30

Great product

Same as above. Took it to my mechanic after a two week wait for a scheduled appointment. Could not send back to have it exchanged. Had to use it and now emblem does not fit on tailgate correctly. Extremely disappointed!

Exact replacement for my 2008 HHR LS. Followed another reviewers recommendation to use monofilament line to saw through the adhesive on the old bowtie, just a few minutes to remove and no scratches on the car. Peeled the left over adhesive off and cleaned up the surface with GooGone. Easy to peel off the backing from the new bowtie, line the tabs up with the holes and stuck it on.

Great fit. Looks awesome and good value for the money

Easy to put in

Very Nice

Intalado llego como lo describen producto chino pero cumple

Just like the original

Better than I expected good quality and easy to fix to the car

Perfecto para cajuela de HHR 2007

Esta muy bien

No es para la camioneta q ahí está especificado dice q ala Chevrolet Uplander no le quedó es falso eso