FOCCTS 12Pcs Black/Transparent 2 Pin T-connector Pin Terminal Wire Connectors, 20-22 AWG, Copper, Plastic, -30°C ~ +85°C

Awesome

Quick and easy to use, does the job very well

The branch parallel circuit connector may need wires stripping back (in 22awg at least) to make an adequate connection. If you have snapped shut the clear flap and need to reopen it to adjust the wires it is very difficult but possible using sharp pointed strong tweezers The through wire connector flap opens more easily and there are two copper cutter/connectors per wire inside but you may need to thin the wire insulation and pack the wire firmly into the connectors with a small screwdriver. The photo shows a 9 volt lighting circuit on my railway. End result? Neat, performs well 9/10. Ease of use? 3/10. Quality? 6/10

These are very easy to apply. Saves on stripping back wires and work perfectly.

I used these on a set of 12v soffit downlighters, made the job an absolute breaze, brilliant product.

At the moment I haven’t used any but I have the single 2 way type. They are easy to use cut wire to length open the clear hinged section put wires through the holes in the hinged section and close. These are a type of scotch lock but better I the fact they are nester, smaller in size and just look better, just right from the micro wires that modern day cars have

Just bought these but I'm confused by the image. Surely the red wire should connect on the left side of the 'T' to make contact with the red wire as shown in the photo. Am I missing something?

Easy to use, great time saver

Handig voor aftakkingen op een ringleiding

Einfache, schnelle und saubere Installation. So wie man es sich wünscht!

Wypróbowałem to złącza w samochodzie. Musiałem wpiąć się w oświetlenie bagażnika. Dzięki temu złączu zaoszczędziłem sporo czasu niewygodnej pracy. Na minus tylko, zamykanie pokrywy, gdyż trzeba użyć sporo siły aby ją zamknąć. Kombinerek nie próbowałem używać, bo bałem się żeby nie złamać klamry.

Un prodotto veramente eccezionale .. l ho preso per fare delle derivazioni su autovetture che utilizzo come laboratorio per fare la formazione per i meccanici devo dire che svolgono appieno il compito. Ovviamente va utilizzato con filo max 2mm. Un po difficoltoso aprirlo ma con un piccolo cacciavite un po di manualità si fat tutto. Io consiglio per una presa sicura nel momento della chiusura aiutatevi con delle pinze

Parfait