Anderson Metals - 57002-0404 Brass Hose Fitting, Connector, 1/4" Barb x 1/4" Female Pipe

I work at an oil change shop that also does several other preventative maintenance services such as tire rotations. We use a pneumatic impact drill to loosen and tighten the lug nuts on the tires. During one of these services, the connect blew up while I using it and that hose had to be shut off until we could get it repaired. The repair was as easy as cutting off the old fitting, getting a new coupler, and a new fitting (this one). A bit of Teflon tape later and we had a working hose again. It's been working for several months without issue. No leaks, hissing, anything. When nothing is connected on the line, it's silent. This is a good quality product, it shipped out quickly and was exactly what I needed.

Cut a 100 ft air hose down to 65 ft and used this connector to put on a male end to plug into the air compressor. Good brass, good pipe threads, a wrap of Teflon tape and then the male end just tightened up easily and no leaks. Didn't even have to bare down on it to get a good seal. A dab of spit on the barbs and it pushed right into the high quality genuine rubber hose. Crimp is holding tight at 120 PSI. Now I just order this type of hardware from Amazon because I am tired of going to Home Depot just to find that they are out of stock or don't even carry what I need. So I'm happy when the part works as it should. Simple things make my day! LOL!

Good quality fittings worked as should would definitely recommend.

I apparently didn't read all of the seller's information on this product. I am trying to install a pressure switch for a water pump for my cabin. I didn't notice that the fitting contains lead until after it arrived and it is therefore not permitted to be used in drinking water supplies. It appears well made so I'll hang onto it for other projects that don't involve drinking water.

As ordered fits perfectly

Used on my Catalina C30 sailboat dockside water project

I had a drain in the basement laundry room that had a 1/8" tube feeding it to my old laundry sink. I renovated the laundry room and put in a new counter/sink. My problem was that the new laundry faucet does not come with a 1/8" hose barb to feed water to the trap every time I turned on the tap. The solution was to get these two items: SMC KQ2T11-35AS PBT & Brass Push-to-Connect Tube Fitting with Sealant, Branch Tee, 3/8" Tube OD x 1/4" NPT Male Anderson Metals Brass Hose Fitting, Connector, 1/8" Barb x 1/4" Female Pipe Then i cut the 3/8" soft copper line that connects the tap to the faucet. Then I inserted the Tee (with the hose barb to female NPT adapter already installed). This allowed me to connect the 1/8" tube to the faucet so that whenever i turn on the tap, it feeds water to the drain to keep the P trap fresh. This part worked like a charm

The barbed end fit my 3/8" hose perfectly. The NPT side fit perfectly as well. The only thing I can de-rate this for is the cost. Should be a little less expensive for what you get.

Exactly what I needed for my air conditioner drainage hose.

SIMPLEMENTE CHlNGON SUPER EXCELENTE ATENCION

good

El producto es de buena calidad, solo que me mandaron una pieza equivocada

Ok