Car Jack 2 Ton Capacity for Pickup Truck 7.76”-16”

Worked as replacement for Chevy Colorado

I used this to lift a retaining wall so that I could will the bottom with gravel. Its a great little poserful jack.

... sand or file or grind the sharp edges off the stamped steel handle, then you'll be fine. You don't want to learn about that on the side of the road changing a tire. I cleaned that up after I cut myself. It only bled a little. Didn't really hurt. Kinda like getting cut with a razor blade. It's a great concept, it could be a great jack, but it would be much more expensive. Clean up the handle where it won't cut your hand first. If you're really ambitious, turn it upside down (you have to hold it or it'll fall over), carefully take the bottom off (it's just 4 screws), screw the inside all the way out, both screws. Then, wipe the grease off that's there and put better grease on the screws and gears, and more of it. Also, pack the thrust bearing in the bottom with grease. Then, screw both screws back in and put the bottom back on. Don't forget the thrust bearing. I cleaned it up and sealed it with silicone to keep the grease from leaking out if it gets hot. It might not have been necessary, but since I was already there. After all that, and adding an axle saddle to the top for stability, it's not a bad jack. I bought this because it advertised to be almost tall enough to jack one wheel off the ground on my Wrangler, and I needed something that would do that. It's almost tall enough, and I'm running 32" tall tires. Any taller tires and it wouldn't be almost tall enough. I use a pad under it, and the saddle on top, and it works fine. It seems safe enough. I really don't think you could dangerously overload this jack, because it's really hard to get it to lift around 1500 lbs. I think the handle would twist before you got 4,000 lbs off the ground. It'll do what I need done, if I have a flat, but I wouldn't try using it for a shop jack. I just didn't want hydraulic oil all over inside the cargo area of the Wrangler. Most cheap bottle jacks leak. So, this will do unless I find something better for what I want, which I haven't done so far. Keep in mind, if it was a better jack, it would cost more. Just be careful with the handle. It's got really sharp edges.

Buen Equipo, tiene Fuerza para levantar un vehículo pesado y extiende bastante más de 24 "

Had to use it twice one time to pick up the front of my truck second time to change a blown out tire worked as you would expect it to

Seems easy to use. Fast operation. Pretty solid.

Excelente calidad, entró sin ningún problema en el espacio dedicado al gato de una Toyota Fortuner 2009.

As advertised There are some sharp edges so be aware Lifts my 5800lb truck

Cumple su función, sería ideal que tuviera resortes pin en las uniones del tubo en lugar de tornillos para agilizar el armado.

Buena compra

El gato bien pero las varillas son muy latosas, hay que estar apretando los tornillos para que estén unidas las varillas Sería práctico si tuviera pernos de presión