Link Handles 65409 Octagon Body Claw Handle for 16 oz. Hammers, 14" Length, Clear Lacquer, Fire Finish

Mine had a large split along the grain that required some chisel work and spokeshave work to remove anything that would hurt me as an operator. I didn’t return because it was for a beater hammer but if I was replacing a head on a different one I would strongly consider it.

The handle I received has a pretty severe twist along its entire length. So much so that the head of the hammer is about 10-15 degrees off to one side. Need better quality control before these leave the factory.

I purchased this handle to font in a 16 ounce claw hammer head. Installed easily with a little shaping and sanding as to be expected. I was done in less than 20 minutes.I like the finish, the look, and the feel in my hand as I use it. Would definitely buy again for a similar hammer head.

I read the reviews before I bought this and one did stand out. I did not listen when I should have. These handles are machined crooked so that when installed the octagon shape is twisted from the head. It is a factory machining issue and not an install problem. If you care what your hammer looks like, don't buy this handle. I'm sure they work but they look like a mistake. I burned mine. On the upside they are solid and nice looking.

The shape and lines are very similar to the old vintage style of handles. I have purchased a lot of new and old handles. This has to be one of the best. I restore old hammers as a hobby. My wife thinks it's ridiculous to own so many hammers. However, how could I trust the judgement of a woman who was willing to marry a guy who restores old hammers for a hobby.If I had one critique it would be the wedge split goes a little too far down. I would prefer no split at all. If u shape it properly and use two steel wedges at 45 degree angles, the installation looks much closer to factory.

Fit my hammer well

Perfect fit for my 1960’s era claw hammer

A solid chuck of wood to replace a broken 16 oz claw hammer handle. Fit well, no bad blemeshes or splits, needs sanding before finishing with oil, that is all!