30g Professional Silicone Glue - High-Flexibility Instant Adhesive for Silicone-to-Silicone Bonding - Waterproof Clear Glue for Silicone Rubber, TPE, TPU Repairs - Sets in 15 Seconds

How can there be any negative reviews about this product. I took 2 1/8 silicone hoses and cut it into 4 different section. I used the included reduction fitting and just put enough around the edges on just one tube- instead of holding for 5-10 seconds-( having previous experience with a rubber glue called KISS- which at the time years ago was the only superglue that was flexible for both rubber and silicone) I held each section with enough pressure to not cave the tube, for 30-40 seconds. Then I went to a 1/4 silicone tube and cut them into 4 sections. I waited a full 24 hours instead an hour or so to set and cure. I now had 4 tubes that were glued using this product. I pulled and stretched it to more than double its length- the silicone tubes were not only glued (fixed) together, the tubing retained its flexibility-with just a little bit of material on the edges-that were a little hard. Most importantly the flow of any type of material- within reason- there was no blockage and then I pulled with real force. The silicone started to tear at the seam but it held and I could observe the flexibility of the product. It tore a little but held and their was no leakage. This product is beyond my comprehension. I didn’t know it even existed. I took the 3 leading silicone superglues on the market and this one outperformed by a wide margin. I did not try to see if it was ready in an hour 2 - I waited 24 hours. Incidentally the tubes looked like they had been welded together. A perfect even symmetrical joint. This the very best product I have used to date. It’s difficult to believe advertising because so much is that if music was advertising- they sing a fine tune. I know this is the real deal and know if you follow my procedure their is no chance of failure. I might add that I did not- did not - use isopropyl alcohol to clean the joints to clean the joints. Just a microfiber towel to wipe the cut ends before joining. I might also add when cutting the silicone tubing into sections. I used an internal metal rod to make as clean of a straight cut as l could. They weren’t perfect. It didn’t matter. 2 days ago I wrote this review and tried another test. I had some old silicone ear tips that I occasionally wear. I made the best cut I could on the stem and it was not straight. It was jagged and out of round. It didn’t matter the product welded the stems together as long as their was enough pressure where the silicone from both ends were crushed( if crushed is the right word) I did not clean the stems in any way, did wash my hands. In closing, this silicone superglue is fantastic. The real deal. I am elated that technology and chemistry have evolved to make this product available and that it actually works better I think than advertised and as good as advertised. It does require some practice and a little finesse to go along with it. Try some discarded material first once it meets your expectations- just do it

Bought the silicone version. This stuff works great. Is bonds instantly within a few seconds, and bonds very tightly to silicone within the 24 hour time period. It's almost as if the bond is as tight as it was before the tear. Be very careful with this product however, if you apply too much it will drip and you have to remove the drips as fast as possible because it dries within a matter of seconds. All you need is a tiny amount when gluing silicone together. Also, wear gloves. When this stuff gets on your hands, it's nearly impossible to rub off.

I was trying to customize silicone dehydrator trays to fit my appliance so I could make fruit leather. 1. Silicone to silicone does NOT become tacky in 20 seconds. It DOES stick to your fingers in 20 seconds or less. 2. It can take up to 10 minutes for the silicone to silicone bond to hold. 3. It is so liquid that it runs all over everything; makes a mess and gets on your fingers and everything it drips on. Should have worn gloves, but then everything would have just stuck to the disposable gloves. 4. Dries clear, but shiny on the silicone, once it's bent, it turns white. 5. It may be flexable, but not nearly as flexable as the silicone was before it was applied. It won't wash off with warm soapy water or vinegar or even acetone. I finaly used an emery board to thin the layers and hope it will wear off eventually. Will not buy again.

I use this to repair silicone props and lemme tell you! THIS STUFF IS AMAZING! The tips it comes with allow for very fine work. Be warned- it adheres quickly and it is very thin. You will become part of the repair if you are not careful! Acetone removes it easily though.

5 stars, the alecpea silicone fulfilled with everything. The only bad was it doesn’t bring the other stuff, just the glue

I needed to glue a couple of silicone things and after research I flings this glue. It worked great! I also used it to glue a couple of plastic things and it still worked! Highly recommend. One just needs to be careful as it's very liquidy.

So it is a cylinder shape of toy that made with very soft yet thick rubber like silicon, aqnd it was torm with a crack, i used the this silicon glue, and only placed the glue on 1 side and pushed the other side, and both sides adhered to each other instantly!!! However, here comes the problem, so yes, the crack is now sealed, i no longer need to worry about it would crack more. but.... after waiting for 24 hours to let it completely dried, the spot that the being glued together now hardened and this is an intimate toy that the silicon is supposed to be making direct contact to my skin, and perhaps with repetitive rubbing motion too, with its now hardened, how is it possible to still provide the same purpose to me as an intimate toy??

I bought this because my cleaning lady broke the frame stand and I thought I was going to have to get it professionally put back on but it worked great and it dried quickly and it was very strong and now the picture of my beautiful deceased father shines bright again on my coffee table

Finally glue works with my swim fins. I had to constantly buy my fins in a few months because there were a weak spot that always breaks. I glue the breakage and add more glue to strengthen the weak points, and now it’s been 9mths

Se fixe parfaitement au silicone.

I used this glue on a medical silicone item. It bonded very strongly, water tight and bends with the material without further tearing. The nozzles make it easy to use and really get into those small places It’s very runny which is useful for small repairs because thick glue can get very messy and look unappealing once dried. However, the nozzle clogs up very fast within seconds of dispensing the glue. Some of the glue is wasted for this reason. It doesn’t dry clear and forms a crust once dried making that area feel rougher. Value for money is good. Can be used for a lot of applications. Comes with multiple nozzles so you can swap them out if the glue dries inside.

Great my wife says

I used it to fix a silicone sex toy. I used some silicone tape as a patch.