ANYCUBIC FEP Film 2pcs for Photon Mono 2/Photon Mono 4, Integrated Design, Easy to Replace

Great product. It works exactly as expected with no issues so far. Installation was easy and straightforward. I use it with my Anycubic Photon Mono 4, and I haven’t had any problems at all. Prints come out great. Would definitely buy again.

Works as expected. Easy to use & durable

My resin printer alerted me that it was time to change the film so I purchased this. I am new to resin printing and this is the first time I have changed the film. This product comes in a sturdy box, is packaged well and includes instructions. At first I thought it might not fit because it is a snug fit but after tightening all the perimeter screws on the resin tray, this product fit well. I will purchase these again when it comes time to change the FEP out.

Works fantastic. Really - this just gives you the two extra plastic frames. They are not already stretched on a frame. As an FYI - the 'from the factory' is stretched at 250 Hz (the "B" key below middle C on a piano). When I hand tightened these, they came back as a "D" above middle C. If you have a good ear, you can hit it like a drum after tightening and compare with an online piano. If not, you can record it and look at the sound spectrum with the free 'Audacity' software. But the results were far superior - I could immediately tell that my previous FEP was worn out (it came back as a lower G# on the piano - so much less tension, which is what I was seeing - delamination of the model after the supports.)

Actually you should change the FEP more often, especially after you had a disaster like parts of the print did not lift off the FEP. Absolutely NEVER touch the FEB with anything. Even wiping it with a tissue will leave scratches you will see on the print. Always "clean" the FEP by exposing the entire area for 30 second, the lift the exposed (hard) resing using a soft plastic spatula from the edge, because even a plastic spatula will leave a nasty mark. At the edge it does not matter so much

Really easy to replace fep, came with two, I only expected one. Definitely will buy again.

Solid and sturdy. If applied correctly and used with care, you can get 2 or 3 life cycles out of one. When the Photon Mono 2 States to change the film. Just hit the reset menu. You'll know when it's time to replace when you start getting an unusually high amount of failed or defective prints or the film is cloudy even after cleaning it. If you have not had a lot of failed prints to scrape off, the film will last though a couple of messages before it actually needs to be changed. That's dependent on your usage, however, and not any guarantee. Keep the tank and the film clean and you'll get longer usage. You can't re-use or change the film from the holder. They are tossed when the film is done and you have to use a whole new assembly. DO NOT try to re-use the film holder with separate film. It will leak and you will destroy your printer trying to save a few dollars. Don't do it !!!

Easy to use and worked perfectly. Will buy again!

Funciona, nunca había realizado el cambio de feo, pero fue bastante sencillo y la impresión salió bien.

Magnífico, se ajystó perfectamente a la impresora 3D y reemplace el original…. No sabía que se tenía que hacer esto y de pronto prendió el aviso, afortunadamente ya tenía el reemplazo….

Totalmente compatibles con photon mono 4/4 ULTRA, no son ACF por lo tanto se deben cambiar los parámetros de velocidad si es que usas la version 4 ULTRA.