Rubber Edge Trim Guard 0.44in wide

Used this edge trim on an outdoor planter to cover some sharp metal edges, and it worked great. It was easy to install, stayed securely in place without adhesive, and provided a clean, finished look. The material feels durable and adds a nice layer of protection. Exactly what I needed and would definitely buy again.

Fantastic product! Excellent replacement for my ‘83 Toyota door jambs. Goes on easy. Fits tight. Makes the curves easy.

It covers a variety of thicknesses which I like. Covers up my raw edges on my custom flat.

Fits what is intended thickness just fine. Reapplied after removing and still does well. Shapes back to normal, cuts well, rugged look adds style. Not sure if trapping moisture will rust it prematurely but time will tell

I cut this into 14" strips to put on the edges of the metal on the back section of my counter stools to protect the new quartz island counter from possible chips. They went on the eighth inch steel snuggly and it appears that they will hold very well. I'm quite satisfied so far. As a bonus, as you can see on the photo, they're barely noticeable and look like part of the stool.

I purchased this to wrap the metal perimeter of my Sprinter van windows. I wasn’t sure it would work but decided to try it. I’m so excited to report that it fit perfectly and I was able to cover the sliding door window and both back door windows! Highly recommend as a much cheaper alternative to purchasing through MB!

Used this to protect Hydraulic hoses passing through 1/8” and 1/4” flat plate that was rough cut. Also used for wiring openings. I am extremely pleased with this material, easy to cut, the metal inserts have remained rust free. Maintained a good grip on metal through the sizing range. I also used it on some sharp edges to protect from cuts.

I used this to repair the leading edge of my 13-year-old car's headliner. The fragile fabric had come detached from the foam board backing where I have emergency lights and cabling run behind the headliner. Looking into the vehicle from the outside through the front window, the ripped fabric and exposed foam looked bad. I manually spread the rubber trim apart then pushed it firmly over the edge of the headliner and loose fabric. Starting on the left side of the window and working my way right a few inches at a time, I squeezed the little clips embedded in the strip tightly closed. I used sheet metal cutters to trim the strip to the exact length. Pros: Easy installation, looks good and covered defect, no adhesive required so easy to adjust, inexpensive. Cons: A somewhat strong rubbery smell which hopefully will dissipate over time.

Great Product. Easy to use and has stayed in place with no Issues.

Worked great for my truck cap!

Fits well hold well, great

Flexible, strong. Good metal clips within. Fairly grippie exterior

Good