VEVOR Metal Access Panel for Drywall Ceiling, 24 x 24 Inch Plumbing Access Doors with Cam Latch Lock, Heavy-Duty Steel Wall Hole Cover, Easy Install Removable Hinged Panel for Wiring & Cables, Silver

This panel turned out to feel larger than we wanted, but it certainly gives good access to the back of the shower in case repairs are ever needed again. Easy to install and it looks good. It should last forever as it is well made.

Very sturdy door. Great buy.

I underpinned a RV using 1 inch foam board and a rock looking stick tile, but I needed a door to access the dump area. I used permanent outdoor tape to apply the door to the underpinning and insulated the inside of the door using the foam board. This worked perfectly.

The metal is thinner gauge then the usually ones I purchase. It's square and mounts easily and works for the purpose of provide ease of access to something behind a wall. I would say if you have a fire code, or outdoor use or structural concern say something heavy mounted above, then this may not be the best choice. However for the price point it is a good indoor access panel for simple access requirements. Example I used this to be able to access a radiant manifold in a basement located in a bathroom and is covered by a mirror. So access is to simply remove mirror off of mounting bracket, then you get access to this access panel, open it, and you can drain, flush the manifold, change flow rates, etc. Once finished, close this access panel, place mirror back on mounts covering the access panel.

easy to install looks great-no issues

Very nice access panel. Sturdy and nice looking.

Good quality & price, thank you

My house has a retrofitted upstairs with hatches throughout the rooms leading to a crawlspace AROUND the rooms. They were fitted with these plywood drywall contraptions when I bought the house. I purchased these doors to replace those hatches. They screw in easily, two screws on each side. The screws on the hinge side go in easiest if you are on the inside of it and close the door. That will not always be feasible so you may just have to drive them in and force the door through. A small cutout in the hinge side where the screw holes go may be useful. In my case I just opened the door and forced the metal to skip over the screw heads and now it's fine. This is just metal. In my case with the attic I have to add insulation to keep the attic air from seeping through the cracks and crushing my HVAC. This is simple for me. I added 2 inches of foam board insulation to the back of the door using construction adhesive and I added simple adhesive foam weatherstripping around the inside edge of the frame to cut off air flow. Problem solved for maybe $30. All-in-all, installation was straightforward and it did exactly what I wanted it to do. I knew I'd need to insulate going into the project so that wasn't a big deal for me. One thing though, the locking mechanism is non-keyed and is welded in. If you hope to replace the mechanism with a key lock, you will not be able to with this product.

reçu très rapidement et correspond entièrement à mes attente je recommande

tutto ok

Good

Gut

Usato per un impianto idrico.. perfetto!