HKS Open Barrel Crimping Tool with 720PCS JST-XH Connectors Kit - 24-16 AWG (0.25-1.5mm²) Labor-saving Crimper for AMP-TE 2.8/4.0/4.8/6.3 JST-SM2.54/XH2.54/VH3.96 & Molex (YM-58BS)

Takes practice but works great and the bang for your buck is significant here.

Crimper works very well, and a great set of connectors is included. I've had good results with it so far.

Picked this up since I needed to rebuild the end stop connectors for my laser engraver and didn't have a crimper with this jaw width. Storage kit is decently organized, dividers sit in tight so components won't move out of their compartments if you toss the case around. Crimper itself is accurate, but does have a couple of quirks - the crimp strength adjustment cam was so tight that even after I pulled the retention screw I had to repeatedly cycle the jaws while holding down the cam to get it to rotate where I needed it, and the handle tends to stick just a little bit at full close. Overall though, got the job done.

Economical set. The crimper are very heavy duty. Very pleased.

The crimp toll is for Dupont connectors and not for the JST connectors. The crimp tool is narrow for JST than Dupont.

The crimper works well and is ratcheting. The first click was perfect to hold a connector in place without it falling out but left plenty of room to feed the wire through for a good connection. All the connectors I make up held great when exposed to some tension. The male ends soldered up just as well. Overall a great little kit to add versatility to you projects.

This kit includes everything to need to replace broken connected or create your own terminations on project for easy clean connections.

Tool works good, but it takes some practice. It is tricky on getting the crimp set correctly especially with small gauge wires.