6 PCS House Floor Jacks Post Pole for Leveling, 11" - 16" Height Range, 6 ton Min and Max Height Capacity, Galvanized, 6 Pack

Had to reorder, there was some unknown issue. This is the second set the I ordered, they work great. Easy to adjust and solid.

Perfect fit good quality very simple to install

These ASTAMOTOR floor jacks arrived quickly and packaged securely. The galvanized finish looks tough and high-quality, and they worked well for initial use. While it’s still early to know how durable they’ll be long-term, they’ve performed as expected so far. One improvement: including clear safety instructions or a visual indicator for how far to insert the top bracket would make setup faster and safer—especially when working in cramped crawl spaces. I hit the maximum jack height on one beam and used shims to compensate—something a simple guideline could have eliminated. All in all, a solid product that inspires confidence. A bit more guidance would make them even better.

Don’t expect top tier quality, but for the price, a quantity you get if you complain you arnt happy with your life, a your bad review isn’t there problem. Second time I’ve purchased these to lift joist, other house is still holding strong over a year later an I’m sure for many more. No you can’t use these to lift the house, so you’ll need to own bottle jacks, but yes they will hold the height the jacks give, sn support the weight.

Worked great

This was a great buy. They are sturdy and are just what they say they are. I love how easy they were to use. Would buy again and recommend you give them a try.

They are what they are

Please note that boxes were open and much of the hardware (nuts and bolts) were missing. Need them in order to set up the jacks. I will be sending another comment as I have purchased 2 sets of these and both boxes were opened on the ends and hardware missing.

These jacks are light yet strong and were perfect for my application. A well designed product.

They work well, but lack a way to back off the extension once fully deployed. All I could do was to use a monkey wrench on the threaded section to lower it.

Need a wrench to tighten up,could have had a bar attached to tighten up did the job.

The actual nuts on the threads are a sloppy fit as well as waaayyy too light duty to support any type of weight. They're metric as well. I tried using a standard & metric thread nut and it won't go on. The threads are actually undercut to a 18.5 mm thread, the nuts are 19 mm. The only way to fix the solution is to use a locking nut, a nylock won't work very well.

This product looked to weak for what we wanted to use it for. Returned them.