VEVOR Motorcycle Lift, 1100 LBS Motorcycle Scissor Lift Jack with Wide Deck & Safety Pin, 3.7"-13.8" Center Hoist Crank Stand, Steel Scissor Jack for Street Bikes, Cruiser Bikes, Touring Motorcycles

Perfect, cheap, no frills, works great. Will hold a street glide for the winter with no problem. Even bought on for my friend because it’s a good deal. I just put a socket on my impact driver to raise and lower it. Great for checking tire pressure, storing the bike with tires off the ground, doing general maintenance, etc. Stays steady, will lift and hold a 1000 bike with rider and stays in place.

Heavy duty raises fast with 7/8 socket and power driver. no assembly required. Extreme heavy gauge steel installed 200 pound rated each rotating locking HF castors. Onto trex decking to add more stability. Worked great to lower fuel tank. Very easy to remove two bolts so aI could drill holes on drill press. The final result exceeded my expectations. Great way to easily, for minimal cost provide a safe lift to any heavy object. This is rated at 1100 pounds. Purchased this to lower and replace 23 gallon to empty fuel tank on van. Should work well for transmission as well if one uses wheel cribs like I have here. The vevor works great with the added height achieved with wheel cribs on the vehicles tires. Wheel cribs are safer than Jack stands. And when a tire needs removal then 2 Jack stands should be used on that corner.

The Vevor Motorcycle arrived on time and was well packaged. The lift arrived ready to use. Inspection and initial use revealed the lift to be well designed, well finished and well assembled. The threaded lifting rod turned smoothly and was properly greased. The thrust bearing at the head end of the rod was well toleranced and also worked smoothly. The safety lock (rod) was a key purchase consideration as it provides an added measure of security beyond the threads of the lifting rod mating with the threaded shaft under the lifting platform. I am looking forward to reliable service from this lift.

Works really well to be so simple, and small. I have a v star 950 and the motor is just a little outside of frame. I had to use 2 pieces of 2x2 to put on jack. Lift worked really well and was stable. I would recommend this jack if your doing small DIY maintenance.

I use this lift to raise up my Suzuki DR650. The bike only weighs about 360 pounds so, in theory, this lift is over kill but it works great. It seems very sturdy and well built. I did wipe some grease on the screw threads before I used it. I don't feel the need to use a power tool to operate it, I just steady the bike with one hand and turn the included tool with the other. There's a lot of suspension travel in the DR so it has to be raised up a bit but there's no problem lifting it. I used it for a tire change day. I took off only one wheel at a time and never felt like the bike was at risk of falling.

Takes a bit to get used to but as long as you lower the bikes weight on the safety pin, it isn't as prone to moving while you work on it. I would say it seems to be the better frame jack for the price. Works well on my v star 250. Make sure to have a second pair of hands on the first lift as its a little flimsy while going up. I use a drill because the tool given is a bit silly for the bulk of the lifting. Better for minor adjustments.

I do not have motorcycle, but I do need something that can raise a few inches and hold heavy stuffs from time to time. Usually, like install kitchen garbage disposer, water filters, and some other situations when you are fixing things. This is the one that can do those jobs very well because it is small enough and low profile.

i definitely needed this for doing some work on my HD. great quality, safety and stability. easy to jack up and down. comes with a pin for locking in place.