PETG Filament 1.75mm, Upgrade Stronger Toughness Printing Consumables, Diameter Tolerance +/- 0.03 mm, 1 KG (2.2 LBS) Spool Fit Most FDM 3D Printer, Black

Yes worked perfectly

Out of all the filaments we use in our business, TPU has been one of the trickiest due to its tendency to absorb moisture and hang on to it. Even with top-tier brands, I've often run into issues like stringing and poor layer adhesion, despite drying the filament for over eight hours. However, after drying this TPU filament for 8 hours at 65°C, it printed flawlessly with no layer adhesion problems and almost no stringing, and it stuck to my build plate without issue during printing and came off with minimal effort. A little more fine-tuning of the generic profile I was using would likely clean up the minimal strings that existed, which came right off the print without leaving any scars behind. The prints produced were for a client order, and they were very happy with the final product and will be back for more when they need their next batch. This is not the first Geeetech TPU I have purchased, as I have used their clear blue TPU previously on other projects, and for the price, quality and consistency of their filaments, I think Geeetech has earned even more shelf space on my filament rack.

Ordered PETG Black Shiny filament. Turned out great on all parts I printed. No complaints for the cost, some light stringing with default settings for PETG on my printer. K1 MAX. Will absolutely buy again.

Really tough getting the first layer with this filament. I would suggest increasing temps by around 10-15 degrees C from your typical PETG settings for better plate adhesion and filament fusing. The tangles are also really tight with this roll, so do be sure to unroll, check, and re-roll what you might need beforehand, especially for long prints.

j ai imprimer environ 4 bobine de noir petg et aucun problème le prix est bon et le produit semble etre bon aussi aucun problème avec mais 4 bobine