DC 12V DIY Thermoelectric Peltier Refrigeration Cooling System Kit Semiconductor Cooler Heat Sink Conduction Module Fridge Mini Air Conditioner Refrigeration

The cooler is well built, and I bought it to play with and see if I could add it to my mini fridge when I was done. You must remember that you will need a 5 amp power supply and a temperature control module. I had it running stand alone in open air for hours turning on and off. I could not add it to my mini frig, but I still have it around for another project.

I have purchased this thermoelectric cooling system for a project of mini fridge and the results are interesting, but require technical attention. Key points after use: Cooling capacity: The Peltier module performs its function. It manages to lower the temperature steadily, but it is vital to ensure good thermal contact. Installation: The kit comes pre-assembled, which is appreciated, but I recommend checking the screws. In my case, I had to adjust them a bit to improve the pressure on the plate. Noise: The fan is standard. It's not ultra-silent, but for a workshop environment or inside a cabinet, the noise level is acceptable. Consumption: Operating at 12V, consumption is stable. Make sure you have a power supply with enough amperage (I recommend at least 6A so you don't force the supply). Pros: Good size heat sinks for the price. It's easy to integrate into small projects. Cons: It doesn't include detailed instructions, so if you're a beginner, you'll need to look for external diagrams. Short cables according to your box design. Verdict: It is an excellent choice for DIY enthusiasts. Don't expect to cool a room (it's not a real air conditioner), but for small compartments or component cooling, it works great if the hot air outlet is managed well.

Never used this but I saved it for the fan I bought it but was smaller than what I needed but the fan was the size I needed

Works well, but cools to 70°F.

The hot side heatsink is too small for this application. It needs to be able to dissipate the 60 or 70 watts burned by the device, causing it to run too hot. The device can only cool to a specified delta-t (the temperature difference between the hot side and the cold side), so if the hot side is too hot, the cold side isn't going to be very cold. I tested mine and after the hot side heatsink warmed up to steady state the cold side was close to room temp.

I hooked this up, and it lasted for about 30 minutes. I went to replace the peltier unit inside, and found a 4.8 volt sp1848. 27145 in it. I put a 12 volt unit in it and now works good.

Worked great for my customer’s needs.

The peltier works well. You can feel how cold the small heat sink gets. The large heat sink heats up pretty quickly so make sure that the large (computer fan) is always running when the peltier junction is connected to current. The only thing that needed to be adjusted was that the small fan rubs against the small heat sink and does not turn. The fan needs to be offset from the heat sink. This is not a problem in my application since I will replace the fan with another fan or larger heat exchanger

Perfect to cool down your dcdc charger in your ute tub

Takes 6.5 amps so needs a 240v to 12v converter off shore power when engine not charging battery.

La descrizione riporta 72w di potenza ma la cella ne emette solamente 48. Spedizione veloce.

Tested but temperature can go below 25C. Will have to replace Peltier to see if it's faulty. Driven to 12.5V and 5A after trying at fixed 12V.

Je n’ai pas encore utilisé, c’est pour un projet futur.