TIPM Bypass Cable, Fuse Holder Fuse Adapter,Repair Fuel Pump Relay Bypass Cable Compatible with Dodge Ram 1500 2500 3500 Jeep Chrysler VW 2007-2016, 14AWG Wire/20AMPs Replace CBWPR091AA

The perfect fix for my 2011 Ram 5.7. Saved me a thousand dollars. Very easy to install.

I got a fuel pump which in all honesty I could've purchased on Amazon but besides the point. This was perfect. Able to use it and get my car fixed to an extent. waiting on my other parts to come in to finish the job and I'm back on the road.

Used on a dodge truck . Everything worked great

Got this cheap cable to bypass the fuel pump relay on a 2012 Chrysler Town & Country with 143k miles on it. We had start issues for a while, and when i plugged in this cable, it fired up immediately, indicating a faulty fuel pump relay. Note(!!!) This is not a permanent fix, it can leave your fuel pump running even when the engine isn't running, draining your battery, and it can cause fire hazards. The permanent fix is to solder on an external fuel pump relay, or get the little circuit board device from Vertical Visions that fits right into your TIPM. But it works great for figuring out if it's the pump relay or the pump itself. Just don't use it as a permanent fix.

This reviewed was a life saver so reposting it again so more of you can see it. This product works great if your fuel pump stops working because of the faulty non serviceable fuel pump relay. I'll save you the hassle installing this jumper harness because this seller is no help in that department no instructions or anything 🤔 You will be using m7 and m25 fuse ports m7 is rear heated seats you probably don't have and m25 is the fuel pump fuse (20) amp that supplies power to the faulty fuel pump relay. On m7 fuse port you will plug the jumper harness in with 2 (20) amp fuses installed into the jumper. ***on m7 you will plug the jumper into the left side of the fuse slot. if the 20 amp fuse to the right is in the way remove and discard*** M25 you will install the other end of the jumper harness into the fuse port with only 1 (20) amp fuse on the top side of the harness see first attached picture. If done right the van should start and idle and your battery won't be dead in the morning unless you have a bigger problem elsewhere. I'm not a mechanic and this is in no way advice you should seek a professional when attempting this😉

Very good product I give it a five star rating

Worked and easy to install

Worked great, bypassed the 12 power so the dashcam would shut-off with the key. No more dead battery after two days.

Muy bien hechos y muy practicos

good

Worked while I needed it

I would highly recommend trying this before spending money on replacing your TIMP.

I bought this for the day that would have come, which it did, and it’s only then I realized that this is mini fuses. Not micro, as needed for my Ram. So this purchase is useless