Wittboy Weather Stations With Outdoor Sensor Wireless, 7 In 1 Weather Station with Wi-Fi Hub Upgraded GW2000 Gateway, Accurate Weather Assistant for Home Garden Farm 868MHZ

First - this Weather Station MUST have a Wifi and Internet connection throughout your home. You must also have a Smart Phone (with latest Android or IOS O/S) and a PC to be able to collect and view the data. The initial set up routine is a bit tricky and the supplied leaflet can be a bit confusing! I suggest you install the Ecowitt APP on your mobile phone and create an account (free) before you start. Then ensure your mobile phone is connected to your 2.4GH Wi-Fi router (NOT 5GH) Then via the APP on your mobile phone install the HUB carefully following the guide instructions shown on your mobile. It took three attempts before I got it set up, but all successful in time. Then instal the AA batteries in the Station itself. That should then soon register with the HUB and thus data visible on your Mobile phone as active. If you also send data to Wunderground (or other web site) the APP on your mobile phone has a page in MENU under OTHERS and DIY Servers to register your device. Then install the station itself in the position you prefer outside. The data then sent to your mobile phone and (and PC web page) is remarkably detailed and the graphs fully customisable for display DAY, 24 Hours, Week, Month etc and viewable in Landscape or Portrait. Landscape is more detailed and easier to view. As far as I can tell the data is accurate in comparison to conventional thermometers and barometers, and rainfall seems accurate in comparison to a previous now failed weather station. Humidity and sunlight/UV also seem accurate as far as I can tell. Wind speed and direction I have no way of comparing, but seem good. Each measuring data point can be adjusted to compensate for local conditions in settings (ie height above sea level etc) Alarms can be set for certain conditions as warnings etc. All in all I am very pleased with the unit and the data it supplies and the way it can be displayed. My only criticism would be that the INDOOR temperature and humidity sensor is NOT remote and is connected by wire 1 meter long to the Hub itself, so it can be tricky to place the sensor in a suitable place - as you are limited to mains power supply socket location etc. POWER SUPPY NOT provided but any 5v DC supply with suitable plug to the hub is fine. However the socket in the hub is NOT same as those in mobile phones. This is the third weather station I have owned over 15 years and is by far the best and comprehensive, though was also the most costly! From the Ecowitt web page of your weather station on your PC, it is possible to export data, into Excel format Am very impressed so far, though I cannot vouch for reliability or longevity but it seems well made and robust. The pole socket is for 1inch pipe/tube and has locking collar to tighten it in place.

Really impressed with this so far. Very easy to set up, I had a bit of a query about the set up and I got an answer to my question very quickly so that was good. Loving the fact that it has no moving parts - I never really believed my previous weather stations when it came to the wind detection because the dreaded pole wobble seemed to cancel out the speed and the rotating windspeed detector would inevitable seize up in the end. Where this set up really excels is the wealth of info you can draw from it and the accessibility of that info. You have all the data set out very clearly in all sorts of graphs and charts and they are just there on your phone / laptop / tablet where ever you are in the world and then see data from every connected weather station in the world all set out in detail so if you are a weather obsessed individual you really can not ask for more. Plus there is no additional charge (not yet anyway!). By far the best weather station I have had, and I have had a few.

Ridiculously easy to install, I plugged in hub and paired with app, then put batteries in everything and it was just "there" done, then just consisted of tightening it on the end of the pole. (bought separately) It's only been setup a few hours but sensors are quite in-depth and I purchased a separate wireless thermometer (WH31) to put in my shed, updates frequently and signal has no issues. I've paired it with my Home Assistant, to aid in temperature regulation and irrigation of lawn/plans, setup was one of the easier HA tasks as between the ecowitt app & integration all the detail required was quite clearly provided and accurate, sensors available in HA 'out the box' are as in my screenshot. also worth keeping in mind the central bit of the sensor on top appeared lop lifted/lopsided as if it may have been damaged but after checking photos of others it appears to be normal.

I’ve only had this for half of a week so far. I’m very impressed by how easy it was to set up and the quality and amount of information that it can provide. I have an alert set up to let me know when it’s raining so that when I’m away from home I can park up my robot lawnmower so that it doesn’t dig the soft ground. The uv index will be great to see to avoid getting sunburned on overcast days. It seemed to charge very quickly on a bright day when I installed it and the charge seems to hold quite well. I’m not sure if I’ll need to use the heater element at any point so I have it tie wrapped to the mounting pole, I would have liked to be able to remove it completely or to be able to secure it in a better way. Only time will tell if this survives a rough winter, we get very heavy winds and I also wanted this to help us prepare for that. So far so good and I would highly recommend, I’ll update further if it stops working. Update; Rain often takes a while to be detected, disappointed in the lack of accuracy here. It often reports rain beyond when the rain has stopped also.

Bought this to replace a Froggit weather station that had become unreliable. The outdoor sensors had packed up as the moving parts had failed. This Ecowitt has outdoor sensors with no moving parts, so I am hoping it will be more reliable? I chose one without an indoor display, as I hardly ever used it. This one has an App which is really easy to use and it was simple to set up. The outdoor sensor is about 25 metres from the hub and there are no problems with reception. I have set alerts for low temperatures and heavy rain and now get reliable alerts on email. The system speaks to my Wunderground account with easy setting up. Really pleased with my purchase and would wholeheartedly recommend this to others.

I have had this equipment for around 2 months now and I like the ease of install and set up for WIFI, and the ability to join to Weather Underground and WeatherCloud etc. I have mine on a pole I bought at a local diy store above a fence, only around 2 to 3 m off the ground so the wind readings are pretty hopeless at this height - although I wasn't too worried about that. Realistically all models fail in it being impossible to measure all features (temp, rain, wind) accurately at an 'ideal' height. If you want to do that you need the early Davis gear or something similar where you can site the units separately. Rain needs to be at ground level, temperature at about 1 to 2m and wind ideally at 10m. It is important to place this unit in the open, including being exposed to full sun however for accurate-ish readings of most features. I have found that when the sun shines on the unit the temperature is reading 2 to 3C higher than local readings and my 'official' gauge inside a larger stevenson style screen. I therefore choose not to share my readings publicly from this system as they are way off. So, it really depends what you want this for, but unsure how and if any others have avoided inaccurate temperatures under sunshine/bright conditions. I think possibly UV and Radiation (w m/2) is reading too high as well. I've had readings of 9 in the UK already and it's only April! I do rate the haptic rain gauge though, had not used one of these before - but last month for instance it was under 1mm different at month end from my standard gauge in what was quite a wet month. Possibly overreads a little in light rainfalls and underreads in downpours (by up to 5mm). A good starter kit for would not recommend if this is your only one and you want really accurate readings.

This has been the best weather station I’ve had. It has no moving parts, like an anemometer or rain gauge. It uses lots of new tech that I really don’t understand. This has certainly been the longest lasting one. I’ve had to change batteries in the unit a couple of times but it’s no hassle and the unit connects back straight away. We bought a unit for the kitchen that connects to it and shows all the info. I have found that there’s a robin who isn’t bothered about the bird spikes. I suppose it deters bigger birds. Overall, I’d say this is very good.

Wanted a decent weather station that would work with Home Assistant. Asked a question of Ecowitt - blinding fast response (yes, you knew that, didn't you). Chose the WS90 with the GW200 gateway and the lightning sensor too. Set these up in the EcoWitt app and thought - "right, down to the hard part - making it work with HA". Well, that was wrong it was what's the word - oh yeah, trivial. |Had a slight oddity about "There's no Wind Chill!" then read and it is only calculated above a certain wind speed - and yup, boys and girls, it is there. So what's the downside... Well they both use 2 * AA batteries - up a pole, not ideal. Looked around, few things I could make work, but thought "Let's ask Ecowitt". ANOTHER blinding response and yes they do have an extension for the WS90 not the Lightning, but I can adapt the WS90 one), so that's going to get ordered (don't think Amazon do them though). Overall working - tick, Support - tick, Happy bunny - TICK.

Easy to set up, after 6 months working well with good data

Readings are accurate, give or take a degree, integrates well with Home Assistant. Note that the gateway, GW2000, kind-off supports POE. You may need a POE splitter.

Ich habe die ECOWITT Wetterstation auf meinem Balkon installiert, mit freier Sicht zum Himmel, und bin wirklich begeistert von der Leistung. Trotz direkter Sonneneinstrahlung liefert die Station erstaunlich genaue Temperaturwerte – das hätte ich so ehrlich gesagt nicht erwartet. Auch Luftdruck und Luftfeuchtigkeit wirken absolut plausibel und passen gut zu Vergleichswerten. Der Regensensor reagiert zuverlässig, sobald es anfängt zu regnen. Die exakte Niederschlagsmenge kann ich zwar nicht im Detail überprüfen, aber die Erkennung an sich funktioniert einwandfrei. Besonders positiv ist die große Menge an bereitgestellten Daten. Hier bekommt man deutlich mehr als nur die üblichen Standardwerte – ideal für alle, die gerne tiefer analysieren. Für Statistik-Fans oder Technikbegeisterte ist das wirklich ein Highlight. Auch die Integration in Home Assistant ist hervorragend: Die Einrichtung war unkompliziert und läuft seit Monaten stabil ohne Ausfälle oder Probleme – genau so wünscht man sich das. Ja, der Preis ist nicht ohne, aber aus meiner Sicht absolut gerechtfertigt. Wer eine zuverlässige, smarte Wetterstation sucht, macht hier nichts falsch.

Utilisateur d'une vantage pro 2 depuis 15 ans avec des pannes régulières et des pièces d'un coût excessif, j'ai décidé de voir ailleurs. Aprés avoir vu de bon commentaires sur des forums météo, j'ai acheté cette station. Bon marché avec une ribambelle de capteurs de bonne qualité. Facile à installer, données analogues à la vantage pro 2, une application avec une débauche de données intéressantes . Cerise sur le gâteau, une intégration facile à une centrale domotique... Bref à acheter les yeux fermés.

Llevo años de experiencia en el ámbito de la meteorología y he pasado por 2 o 3 marcas conocidas de equipos. Necesitaba un reemplazo de una de ellas, y lo que me llamó la atención del Ecowitt Wittboy fue la ausencia de piezas móviles y las razonablemente buenas reseñas en webs especializadas. La entrega fue dentro de plazo, y sin sorpresas. El producto, bien protegido en la caja y sensación de robustez y buena finalización en todos los sentidos al sacarlo del envoltorio. El montaje fue sencillo siguiendo la guía breve. Hay opciones más avenzadas sobre calibración y otras opciones que se encuentran buscando un poco en la web. Tras varias semanas de instalación, debo decir que estoy gratamante soprendido por las prestaciones ofrecidas por ésta estación. Me preocupaba mucho el sensor háptico de lluvia, que rompe con los tradicionales pluviómetros de "balancín". En éste sentido, tras alguna mínima calibración, los resultados son más que correctos. En cuanto a viento, lo mismo pero sin necesidad de calibrar nada. Sólo asegurarte de encarar la muesca del Norte, al Norte XD. La temperatura, tema estelar en éstos aparatos.... Los primeros días, a pleno sol de mediodía (está en una azotea muy expuesta) daba máximas un par de grados más de lo real. Lo cual no está mal del todo en equipos de éste rango de precio. Pero al poco tiempo descubrí la opción de "compensación de temperatura" mediante el cual se corrige en función de la radiación solar detectada y otros factores como el viento. El resultado es un soprendente calco a los valores de estaciones profesionales en la zona. Los datos se vuelcan cada 8.8 segundos, lo que permite un seguimiento al instante. La humedad, quizás tiende a leer un pelín por debajo en horas centrales del día expuestas a insolación. Los sensores de UV y radiación solar aún están en fase de evaluación pero pintan bien. Todo ello se puede calibrar en los ajustes. La interfaz de la app es sencilla, sin grandes lujos pero no falta de nada. Compatibilidad total con plataformas como Wunderground o Weathercloud. Por todo ello, recomiendo abosultamente éste producto a aficionados y no sólo aficionados!