Inner Shifter Boot for Jeep Compatible with 1997-2004 Wrangler TJ and 2004 Wrangler Unlimited LJ - Replaces OE 52078558 - Part Number 18886.95

Fit as good as factory

Perfect fit.. I've been in the automotive business for over 40 years I've owned Jeeps for over 30 a total of six Jeeps actually perfect fit just what I needed thanks guys

Installed on a 2001 TJ. Took a bit of effort to line everything up with prior screw holes but was easy enough.

Worked like the original. Some comments about not having the screw holes but they are punched in the steel ring. Use a nail to punch through the rubber.

Rubber seems to be of good quality, but it does not form a seal around the shift lever. Mounting ring holes need to be drilled through rubber- use your old ring for your bolt pattern and drill accordingly.

NO MORE BLAZING HOT AIRBON MY FLOORBOARDS!! 2001 TJ. Fits good but was a little loose on the shifter, probably would have been fine but my feet have cooked for so long I didn’t take a chance and taped it to the shifter just in case.

I just purchased a used Wrangler TJ and the one that was installed was the wrong boot. I found this and it fit perfectly. The quality was right on, installing was easy the screw holes are cover by the rubber but that's a good thing it creates a water and air tight seal.

Fit really well good price for the product

I have a 06 TJ Wrangler and the OEM inner shifter boots are a nightmare. I replaced mine 2 times to only have the boots split and fall apart within a month. Being a creative person I experimented with a few aftermarket inner boots of different shapes and sizes. After a few fails I decided to by this boot. I cut an aluminium sheet to fit the opening in the tunnel of the TJ. I proceeded to find the location where the shifter runs through the aluminium plate and then I use a 100mm holesaw to drill a large tidy hole through the aluminium. I then marked where the screws go through the rubber boot and drilled the holes and inserted some rivnuts/zertnuts into the holes. I fixed the rubber boot to the plate and it worked perfectly. The boot has been in the car for over a year now and it is still intact and working as it should. If you do this mod then make sure you use foam rubber with adhesive on one side to form a seal between the plate and the tunnel metal. Its a conversion you wont regret. This will stop water entering the car and it will also eliminate the extreme heat that enters the cabin from the catalytic converter, transmission and engine. If you feel your center console where the shifter is located and if it is hot then you know your boot needs replacing. Same thing if your front carpets get wet when it rains. Dont pay $300 plus for an OEM boot that will fail soon after you install it. Do this mod for under $50 and you wont regret it. Also these cheaper earlier model boots are readily available on the net unlike the 05/06 TJ inner boots which is becoming harder to find. Ive tried and tested this early model boot and it can be done and it does work well. I hope that this review helps my fellow 05/06 TJ buddies worldwide. Keep Jeeping and go topless with a smile on your faces my friends. ;-)

Se ve de buena calidad

مناسب وجيد

This fits with the older tjs but not the newer ones with the nv3550

Tudo conforme anunciado