Right Angle Screwdriver 32-Piece 1/4 Inch Mini Ratchet Set Low Profile Offset Bit Set with 72-Tooth Ratcheting Wrench Stubby Ratchet 90 Degree Screwdriver for Small Spaces

I needed a small profile ratchet set to replace TPMS sensors on an Equinox. This worked great to remove the torx screw from the sensor while it was on the wheel prior to removing the sensor. This kit came with the size 10 torx that was required for the job. The included zipper case is a must have also.

Came in clutch for headlight alignment on my newly installed projector headlights. Fit well in a tight space. Magnetic feature came in handy for this application since no screw fell off. No missing parts. Bits lock in place nicely. Good feeling quality. My only critique is wish it were 2 inches longer for leverage. Lighter for scale.

Nice set for small bit ratchet, this comes in handy for tight places when ordinary drivers are too big. Using this can be daunting due to being small scale, no texture on the polished chrome ratchet makes it very slippery. I had to add some No-slip gripper tape, the type used for skateboards and stairs treads. The bits can come loose and fall out under normal tightening torque. I think bits need to fit tighter inside the ratchet and a stronger internal magnet is needed. If I can find a 4mm neodymium magnet, it would fit inside the ratchet opening to help retain the bits. I’ve seen a pass-thru type of these micro ratchets that might be more secure because the small indent on the bits keeps better retention. The case is a clear plastic that keeps bits secure inside corresponding slots by type with sizes printed on the holder and locks securely so no accidental spills.

Is it possible to be in love with a wrench? Exceeds my expectations. Fit and quality of construction excellent. Where have you been all my life? The experience of tightening fasteners will never be the same. The attachment bits are fantastic.

Perfect for tight spaces. I used this to remove a hex screw from a pocket hole on my son’s baby bed. A normal hex key took me ten minutes per screw due to limited range of motion. But this let me do each screw in about a minute! A huge time save that made the purchase worth it. The head of the tool is right around 3/4” wide, so fairly small. The directional switch is easy to bump, so just watch your finger tips. This provides the perfect amount of torque you’d need for furniture hardware. Tool weighs about 3 oz

Small tool, sturdy metal to rachet loose or tighten a hard to reach screw. Works as it should. Have used in many spots where screws were not fully buried. Simple, good magnetic bits, I would recommend it.

Needed a narrow ratchet to fit a very tight space on my truck. The screws I removed were not super tight so this tool was perfect. Not sure it would be effective on a tough job but works great for reaching very small areas.

really greasy / pre greased. didn't include hex bits