GSCIT Club Melamine Edge Banding, 3/4 inch x 25ft White Edge Banding with Hot Melt Adhesive Pre-glued Cabinet Edge Banding Flexible White Veneer Edging for Plywood Furniture Table

Worked perfectly just as instructed....IRON IT ON . I used a small hand held craft iron WONDERFUL!! Be careful not to bend the tape too much .... cracks easily. The paint went on so smoothly too. 2 coats 😊

This edge banding is almost an exact match for the edges of white MDP board. It's easy to cut and goes on with a standard iron. It did take about 15 seconds with the iron to securely fasten a 15 inch strip. So far, it seems to be holding tight.

This stuff works great. You just go over it with a hot clothes iron. I trimmed the edges with an edge banding tool and cut it to length with a utility knife. Nothing to it.

It looks good Mounted easily with the iron. Only issue was the first 5 or 6 wraps of the roll were busted up and damaged, for something that is brittle I would've expected a box not just in a paper package bag.

Impressed with the quality and ease of installation. The edge banding often didn’t even require trimming with a knife—once folded, it cleanly breaks off exactly where you want it. It adheres very well, which was a pleasant surprise, and bonds immediately when ironed. I did go over it a few extra times just to be safe. The fit was also perfect. Overall, very satisfied with this product.

Looks great, but it doesn't hold as well as I would like. If your finger catches the edge it can peel off.

I was preparing to hang some cabinets and needed to plane the last cabinet to the leat 1 point I planned in the wrong direction like an idiot and a piece of the front I was furious at myselfwent to the hardware store To look for stain, but most of them go on clear and no matter what I would do. It would never actually look right because of the jagged. Corner of the cabinet where the veneer was ripped off. I even tried wood pudding and it looked horrible. I was so excited to find a product that looked like. It might fix my cabinets Have an oak finish which has some variation in color this problem. This product is a very thick vinyl and very good quality. I took a piece of PBC lattice molding that I had primered I. Put the wood grain tape on the top, then folded it over so that the sides were also covered. I was shocked to see how well it matched. I put it above the doors as you can see in the pictures and Brad. Nailed it to the top of the cabinets. You literally cannot tell there was ever a problem? What an amazing problem. Whoever thought of this should get a prize. I am so grateful to have found it. My cabinets look amazing. It's very thick vinyl.The adhesion is great. I even took it back over to my local hardware store and the guy.Who usually helps me was also amazed.I brought pictures along and he couldn't believe it.It was better than anything else they suggested

Easy and quick to apply with a hot iron to activate the adhesive. The banding width was perfect for our 3/4" shelf below the kitchen sink. Gave the shelf a finished look. Before and after photos attached.

Redid my kitchen cabinets with GSCIT Club Black Wood Veneer and they look marvellous. This my first at temp at this and GSCIT veneer made it so easy. I used a regular clothes iron on cotton and it was like ironing a pillow case. Great product and exceptional new appearance in my kitchen

Had a couple of shelves where a fluid spill cause the original trim to peel off. This product was easy to apply and trim. Just used a standard clothes iron to apply it. Looks good and has stayed on securely since I applied it.

Commande bien reçu

As long as I was careful with alignment, this tape fitted exactly my kitchen shelving thickness. I only had to sand a bevel to finish. Glue was good, I just used a cheap iron. Very happy with the result.

Exactly what I ordered