GearIT Right Angle Banana Plugs for Speaker Wire (6 Pairs, 12 Pieces), 90 Degree Pin Plug Type, (Non Conductive Coating) Spring Clips Speaker Banana Jack Terminals (Support 12 AWG to 20 AWG Wires)

Buen producto

works great

Great right angle banana plug for speaker wires and jacks. I bought these to connect my new SVS speakers to my desktop system. I used 12ga wire without issue. Note that there is a piece of heat shrink tubing inside the barrel that you need to remove after loosening the screws almost all the way out. The included screwdriver was up to the job to get the heat shrink out. I suspect it was in there to give the set screws something to press against and keep them from backing out to lock the outer barrel on. Strip about 5/8” of speaker wire and twist the wires before you insert into jack. I pushed in far enough that the insulation just inserted into the barrel but not too far that the set screw contacted it as the set screw will then be too long and the screwdriver won’t be able to tighten it all the way. Tighten set screws all the way down flush with the outside of the barrel so that the outer sleeve will fit over. I find that a good silicon insulated 12ga speaker wire is the best fit and will handle any load without issue. My SVS prime satellite speakers totally rock using this set up when paired with the SVS 3000 Micro sub for my desktop system. I’ll purchase more of these for future use. In the end I found them to be of good quality and installation was simple once I figured out the heat shrink was inside the barrel. The price is good and sound quality is on par with any other speaker wire configuration I have used over the years.

Solid banana plugs. Good quality.