5Pack 3.3FT/1M LED Channel Aluminum U Shape Silver LED Strip Diffuser Channel with Milky White Cover Easy Installation U1SW WW 1M

Installed above and below my kitchen cabinets with a 6 foot LED light strip. Quality aluminum channel and diffuser.

Easy installation. Worked as expected. Look really nice. Diffuses string lights well. Great value for the price.

The product was as described. Worked perfectly

Short and sweet it does what the description says it does it looks great I’m not Bob the builder so it was a little challenging to install but I’m sure besides that the product is good to go

I absolutely love these channels. They were easy to cut using, my miter saw. The diffuser snaps into place easily and there is also a protective film if you intend to paint an item after the channel is installed. The only issue I had was drilling a hole in the aluminum in order to run the power. However I may have had the wrong type of drill bit. Five stars across the board for Muzato

I am confused. I want as narrow a channel as possible to fit 8mm led strip. I ordered this as the description said 12mm, which I thought was the outside dimension, but it's the inside dimension. Is there narrower?

No complaints here. These aluminum channels worked great for my setup. The cover/diffusers fit snugly and do a good job at reducing the glare of the individual led lights on the countertops. These channels eliminate my concern of the tape lights not wanting to stick to the bottom of the cabinets in due time and will make cleaning much easier as well!

This is your standard LED aluminum channel - only a little less expensive than identical products on Amazon. I use these for installations with polished stone counter tops where reflections of the LED dots are annoying or for cabinets that do not have an extended molding / recessed area underneath. Like another reviewer said, you can still see the individual LED's through the frosted plastic cover but it is much less focused. The channels and plastic covers are easily cut with a fine tooth hacksaw. Mounting is very easy with two screws and clips supporting an entire section. You can install two sections butted against each other for a longer run but you have to be sure the alignment is perfect. My only gripe is the end covers. I wish the hole was a little bigger to fit 18 gauge wire. One thing to keep in mind is that the covers do reduce the LED brightness a little. Higher density (300 LED's / 5m roll) look better and have more usable light than lower density (150 LED's / 5m roll).

This LED housing does absolutely nothing to be honest. It was difficult to install the metal tracks on and the diffuser covers that slide on feel like flimsy pieces of plastic that can snap at any given moment. Does not diffuse the lights as advertised you can basically see each individual bulb on the track. Especially for the steep price point it should at least do SOMETHING amirite. As someone else's review stated it definitely does give "cheap strip club dance floor" vibes in my room. Returned the item and bought two $7 pieces of corner moulding from home depot to reflect the LED strips onto the wall instead and had a wayyyy better result.

Hard to use the plastic diffuser for the track does not fit well into the track would not recommend this product in fact if I could get my money back I would.