10pcs Pack Strip Wire Solderless Snap Down 2Pin Conductor LED Strip Connector for 8mm Wide 3528 2835 Single Color Flex LED Strips

It’s good

excellent quality

Good product and worked well with my leds. I installed multiple strips in different areas on my sailboat and this allowed me to utilize the entire roll instead of buying multiple rolls. The reason i gave it a 4 and not a 5 is bc there was one connection that had no continuity on the ground side. Product looked fine as far as pinch points and solder. Glad i tested as i installed or itd be a 2, lol. I would order again and recommend.

if you’re anything like me and soldiering isn’t your best friend, then these can be your next best friend, when it comes to led light strips! I can’t explain how much easier working with led light strips is now. Highly recommended!

I only needed one to repair a soffit light, but it was worth $10.00 in ease of installation.

hard to uses on 2835 led strip, had to bend strip to get inside base them had to left up contact pin to slide up, lucky the snap on cover pin the contact down, i spend minutes on putting them on, bend do this for years , never had this problem. 2nd they gotten pricier for less, use to find coupling with two females end just cut in half, i am looking some where else to but again for the next job i have.

If you are installing led strips and need to do some cutting or connecting multiple strips, this is for you. I don't mind soldering when necessary, this is a faster and easier way to get things done. These would also allow for easy replacement of faulty led sections in the future.

Used these to connect led strips to the ceiling lights in my RV. The little plastic hinge can be tricky to close. Just be patient. I only had 1 that I had to trash and that was my fault for forcing it. Make sure the led strip is lined up straight before trying to close it. It's tight but it'll work.

Good quality and reliable.

Did exactly what I wanted. Easy to fit. Could have done with longer supply cables but ok otherwise

The items were provided with the plastic solderless on both ends. It is not a big deal, but it is short and then I need to cut another few mm from one end to be able to connect it with the power supply. Also the connection is not good as it's not working 100% of the time.

I used this with LED strip lighting to convert my RV florescent light fixtures over to 12v LED strips. These made the job fast and easy.

Had to buy to use the 3rd reel of a kit.