AADIV-001 Super Suit with Dive Housing for HERO7 /HERO6 /HERO5 , Clear, One Size

If you need the same great protection for your new Hero 5 as you have had with previous GoPro models, this is a definite buy. It is the same materials they have been using for years, and they work great. The housing comes with an open back door and two waterproof ones, which is nice in case an o-ring gets damaged on one of them. Also, compared to GoPro's other accessories, this is one of the most fairly priced, especially for what you're getting. One more thing to keep in mind is that the filter size for this case is different than the Hero 3+ or 4 housings (not sure about older models, but I would assume they are different as well), so if you have filters for those you will need to get new ones. The one thing that I didn't know before purchasing that I wish I did is that you actually have to remove the front glass panel from the Hero 5 before putting it into this case. This isn't a huge issue, but it is hard to get off and feels like you might break it if you're not careful. Also, that little glass panel is quite small and could be lost or damaged easily, so also be careful not to lose it (though they do sell replacements). So to conclude, this case is amazing. If you need better protection for your camera or need to go below 30 feet underwater, you should definitely get this. As long as you're careful with the Hero 5's front glass panel, you should be all set.

Perfect. No leakage etc.

I purchased the Kupton underwater housing and the GoPro Super Suit for my Hero 7 Black. I have not yet tested either underwater. THIS IS AN UNSOLICITED COMPARISON AND I DO NOT WORK FOR NOR AM I IN ANYWAY CONNECTED WITH KUPTON OR GOPRO. 1) OUT OF THE BOX: Advantage GoPro. The Kupton came in a small, nondescript cardboard box. The GoPro came in a nicer package that you would expect to see on a store shelf. 2) PRICE: Advantage Kupton. The Kupton housing was roughly $15 cheaper than the GoPro on Amazon, coming in around the $20 price point. 3) BUILD QUALITY: Advantage GoPro. This is a HUGE difference between these two housings. Both plastic housings feel substantial, however, THE HINGE ON TOP OF THE KUPTON THAT LATCHES THE BACK IS A VERY WEAK POINT compared the GoPro. This WILL BREAK and much sooner than later. This could ruin a dive trip. The GoPro latch is very substantial and looks as though it will stand up to the constant opening and closing of the housing. The Kupton will not. 4) USABILITY: Advantage Kupton. You literally have to remove the protective lens from your GoPro in order for it to fit. The Kupton accepts the camera without having to do this. It is not the easiest thing to take off either. OVERALL IMPRESSION: First, DO NOT TRUST EVERY REVIEW. I can see a competitor company purposely skewing reviews to get people to buy a subpar product on Amazon. Now, having purchased both the Kupton and GoPro with my own $$, I would recommend the GoPro Super Suit over the Kupton for one reason: the hinge mechanism. This small metal locking clip has the potential to make or break your scuba/snorkeling trip. Granted, the Hero 7 is waterproof, but you’re shopping for an underwater housing so let’s assume you are going to house your camera regardless. Now, if Kupton were to redesign this latch, they could very well claim to have the best housing simply because you do not have to take your camera apart. Another point too is, if something does happen to your camera, it is almost always better to be using an housing made by GoPro than an aftermarket brand. NOTE: Both the GoPro and the Kupton have small actuating pins that press the on/off and record buttons while your camera is in the housing. I can easily imagine these pins wearing through the rubber buttons on your camera. I may rig something up for mine so this does not happen.

I have been recording track days for a few years, and the Super Suit (with the full door) is the best option for getting reduced wind noise. I have a targa car and I drive with the targa roof removed; wind noise will utterly dominate the video playback unless great care is taken. The Super Suit cuts the wind and still picks up the nice engine sounds (My camera is mounted to my rear firewall with the mid-engine in the rear; your front-engine car may play back differently). I tried it with the "skeleton" door, and that still lets through way too much wind noise, so I'd recommend the full door. I can't say that I have tried to manipulate the camera much while inside the Super Suit, other than to start/stop recording, which it does perfectly.

I used this housing to film around Lake Lanier (GA) as I was searching the bottom of the lake for some goggles I'd lost the previous day. It worked perfectly. I comes with three back panels. Two waterproof solid panels and one open panel that is not waterproof, but allows touch screen access. No problems with this housing as yet. Easy to use! UPDATE: I just got back from a 2-week trip where I utilized my camera in a variety of under-water situations. I realized straight away, that this housing is JUST PLASTIC, because it's easy to scratch the surface- which can be a problem when filming... So, I left the rubberized plastic protective screen on the lens window in order to extend the life of the case a bit. I am very happy with its performance, but have a few notes... 1. If you intend to shoot in salt water, make sure to rinse the casing off thoroughly, then dry, before removing the camera from the housing. 2. In salt water (in particularly) and sandy situations, salt (in particularly) or sand WILL build up beneath the unlocking button switch, causing it to be a bit difficult to re-open. 3. Always keep a bottle of fresh water and a towel on you- you never want to open it while it's dirty because the waterproofing lens cap is unable to fit inside the housing, meaning that the lens is fully exposed as there is a much greater chance that water could enter the camera as well. 4. Prepare some "dry strips" or "anti-moisture strips" and place a couple inside the housing beneath the camera (yes, there's room) whenever you intend to work in cold water that runs through a warm environment. This helps avoid moisture build-up along the inside of the case as moisture condenses and is attracted to and trapped within the strips. 5. LEAVE that protective strip on the front lens window...until it gets messed up- because that's at least one accident for which you receive a free pass. 6. Consider investing in protective material to place over the lens cover (think iPhone/iPad protective plastic sheets) to give your casing a mush longer life expectancy.

It is easy to use and works as advertised. My only "complaint" is that it is difficult to get the anti-fog inserts to fit in the Super Suit with my GoPro Hero 7 Black. There just isn't quite enough room so I end up squishing them in there and it is a real pain to get the GoPro out again. But, the Suit keeps my GoPro safe and sound. I dive once a week to depths of around 100 feet and haven't had a single issue or drop of water inside of the Super Suit. It is more expensive than the generic versions out there and I have no idea as to their quality. I chose the Super Suit because I figured that it would be easier to get GoPro to resolve a problem IF there was a problem with the Super Suit than if there was a problem with one of the generic versions.

The GoPro heats up a bit too much. Then it shuts down. Thought about drilling into the device to make to ventilation. While playing airsoft and smashed my helmet against a metal wall and there was 0 damage to the case and the GoPro.

The Suit fits the Hero 5 perfectly. You have to remove the lens cover but that is very easy and quick. I like how it comes with three different back doors so accommodate different situations. One back door allows you to keep the go pro in the housing yet still be able to access the back touchscreen capability of the camera. The other two doors are similar except one can be used to glue a floating foam to make the camera float in case you let it go. This will not allow you to see the back screen of the camera. The third door will let you see the back screen of the camera but it will not let you use the touchscreen functionality. I like the easy but secure clamp on the top. It has a button you need to move in order to open the clamp. This prohibits the back door to open accidently be catching on anything you are wearing while under water or any other activity. The lens cover on the housing is made out of glass and it doesn't distort nor shifts colors on the video or pictures. An additional benefit for this housing is that there are multiple after market manufacturers for accessories and filters that fit this housing.

Carcasa acuática oficial de la gopro. Fantástica calidad, con varias tapas traseras, para poder usarla en el exterior y mantener la pantalla táctil, o para cerrarla totalmente herméticamente en actividades acuáticas o buceo. Muy robusta. Es bastante más cara que las de la competencia, pero con este complemento en particular no me arriesgaría a comprar algo de baja calidad y después tener que arrepentirme. Recomendada totalmente.

Thanks for this my GoPro has survived paintballs and Airsoft pellets. Cheap and good works just fine a little hard on the touch screen stuff but the Seals All good. And I can tell you it's waterproof no paint on the GoPro yet. Fits perfect on my GoPro Hero 7 so no complaints. It's sturdy and good but don't expect to use to touch screen anytime soon.

Para salidas y snorkel para cuidar la pantalla en viajes y caminos. Muy buena carcasa para la black 7 go pro.

What's hard to figure out at first is that you have to remove the lens from your GoPro (Hero 5 black) first. Otherwise, the door won't close all the way. You can check this on youtube, though, and once you see it done, it's easy. After that, it definitely appears to be solidly water-tight. Looking forward to trying it on a dive next week.

Das Case hat uns mittlerweile bei 3 Urlauben und hat uns nicht enttäuscht. Das Case ist absolut wasserdicht auch bei einer Tauchtiefe von 20m. Somit kann ich das Case nur weiterempfehlen:) Bei uns kommt es auf eine GoPro Hero 6 Black und ist passgenau.