Metra Ford Speaker Harness for Bronco 21-Up, Wire Connector Adapter

Since stock speakers are made differently than stand alone ones, this is a must need or else you won't hear anything at all. It's practically an adapter to connect the speaker to the car itself as it already has a connector built in. Stock speakers come with the attachment so you just click it in and that is it. But when it comes to replacing speakers which I did just recently, you would need this to connect whatever it is your using so that the sounds can travel through the connections properly and still listen to the music. Definitely was the right fit and kind. I have a Mazda 3 2016 iSport so if this helps me it definitely will help you!

Fits and works perfectly

These connectors make for a fast install to the factory harness for 2023 F150. If you don't want to cut the speaker wires buy these. Highly recommend for a DIY'er.

These actually work very well if you are upgrading a Ford that has a woofer/tweeter combo with inline filters to use a crossover component set. I don't know if it is intentional but the loops used to bridge from the speaker input to the tweeter output are large enough that if you need to hookup a crossover you can clip them where they bridge from the speaker in over to the tweeter out. You can then hook that to the tweeter out of the crossover, hook the woofer out wires to the crossover input then run a wire from the woofer out on the crossover to your woofer. You then hook your tweeters up to the stock tweeter clip and you have a fully hooked up crossover with no cutting of stock wires.

I purchased two pairs of these, one for each door in my 2012 Mazda 3 I Touring Non-Bose Edition. For the back door/s I installed Kicker 46CSC684 and once I connected the adapter there was no splicing needed. The front doors made these adapters a blessing. Since I was installing a pair of Kicker 46CSS684 component speakers I would've had to do a ton of splicing. These adapters made it so I only had to cut and splice two wires to attach to the crossover. In the attached picture you can see where I attached the adapter and spliced the wires in the bottom left corner. This made my life 10x easier and I hope it does for someone else too!

These connectors really helped with the install of my speakers. The install of my new speakers went very smoothly

Connection is a little loose but it fits on a 2016 Mazda MX-5 Miata.

10