HAMRVL 6-Pack 30cm/1ft 17.2x7mm Led Aluminum Channel System U Shape with Cover, Led Strip Light Diffuser with White End Caps and Mounting Clips Accessories for Under Counter Light Fixture for Indoor

These aren’t nearly as hard to clip on as some of the reviews said they are, don’t be super anxious after reading them like I was. There’s a great video on the product listing and a review that explained you clip in one end, and then apply pressure and slide your thumb down almost like a zipper on the other. It does take a little bit of care but they work and look excellent. They really elevated my display.

Corners are hard to snap on. There is just a tiny ledge that the rails fit into. Would be great if corners were made to fit better. Otherwise no issues

Have these set up on the top of my monitor for when I'm gaming (WS2812b used with SimHub) and they do their jobs. I can't say that I really have any gripes with them. The only thing that I will bring up is that if you want to use the end caps, you will have to trim a little bit of the end of the diffuser. Certainly not a bad thing though, I just wanted to put it out there.

Excelente calidad

I was looking for diffusers for my LED lights and I saw so many that were overly expensive. I could not justify spending a ton of money on something like this. Luckily, I found these. I was a little skeptical that they were gonna be too cheap and maybe not as they were described. Luckily they showed up and they were perfect! They were a perfect fit and came with everything that I needed. I would definitely buy them again!

Okay, from opening it you can tell it’s cheap. I knew my LEDs were not dense so I was expecting to see dots but that’s not what turned me away. It is very easy to break it while assembling. It is like the sizes of the conjoining parts are just a tiny bit different but you can make them work. The clips were ok to me, not great or good, ok. Its just a product that’s going to frustrate you so much that you won’t be able to enjoy the end result…if you get that far. Sending back here, maybe you’ll have better luck.

Great product

I guess you get what you pay for. These come with some ends to put on her to hold the light strip in place. They don’t stay in very well. They don’t. They pop out the end that you put the and goes your light strips right at the end on the other hand when you go to put your light strips in there the wire it better be thinner than a toothpick cause if it is not gonna go through the hole that they put there for you so it bundle it up and use BTF lights three wires in a tiny wires and you try to push it in there. You have to leave a huge gap to get in to stay there and not push the lights out the other side. Can we not waste your money if you want quality set up because the Amber, if you can get it to stay, and if you can get you somehow managed get your wire through

I ended up using 2-sided acrylic tape to adhere this to the bottom of a shelf, but it works wonderfully! The end pieces all have little holes to pass through wires.

自作でLEDバーライトを作成したかったため購入。輸入品なので配送には2週間程度かかります。 製品自体は歪みや傷等は無く品質に問題ないのですが、なぜが梱包していた袋がホコリ等で汚れており、ちょっと不快でした... また、両端を閉じるキャップが付属しているのですが、穴あきキャップは5mm程度の穴が開いているだけで、一般的なLEDテープライトを通せません。もう少し工夫が欲しいです。 さらにいうと、各アルミパーツを連結する仕組みは無いため、ここも工夫が欲しかった所です。

Un poco caros para lo que son y no quitan el efecto de ver los leds y difuminar la luz tanto como creía pero en general está bien. Si está en descuento mucho mejor.

Received what looked like dog chewed products. Everything bent out of shape. Not a single piece was useable.

If you are looking for something that diffuses the light well and is easy to install then this is not for you.