Triplex Power Pressure Washer Pump 5 GPM 3200 PSI 3600 RPM 1" Hollow Shaft with Unloader

I've been using this pump for about 2 weeks now. Roughly 3-4 times a week for about 45 minutes each time. I added full synthetic 10w-30 oil since that is what I had. This pump replaced my AR RKV 4G36 pump. It fit perfectly on my Honda GX390. Removal of old pump & installation of new pump took all of 5 minutes. I was really curious to see if the flow rate was correct or not so this is how I tested it at 3200psi. I have a 15 gallon steel drum. I added 3 gallons of water inside the steel drum & marked it with a sharpie. Stuck my wand with a turbo nozzle in the water. Set my timer for 1 minute. Started my pressure washer. Verified the pressure was set at 3200psi. Pulled the trigger. During the flow rate testing, my pressure gauge read 3000psi. When my timer went off, I let go of the trigger, pressure went back up to 3200psi. I set my motor throttle to idle for about 15 seconds then turned it off. I disconnected my wand to let the water flow to cool the pump while I start removing 1 gallon of water at a time. I removed about 5.5 gallons or so during my testing. I say or so because I was using an old milk gallon jug I was throwing away. You are probably wondering why I was cooling the pump after a 1 minute test. In reality, I got everything ready to do the test. Then I pressured washed for about 30 minutes. When I got done, I set my timer for 1 minute & started my test. You can't just turn off your pressure washer pump off and not cool it down. That will ruin any pump quickly. I also run my pump at 3000psi & not at max of 3200psi. The real question is, will this pump last as long as my other pump did of 6 years. That is the real question. Quality seems good. Sooner or later, I will rebuild my AR pump to have a backup.

Su primer día que la compré, sucedió esto, por favor no vayan y compren

1 inch hollow shaft is too short for motor shaft . it slides over motor shaft just shy of 3/8 of an inch. Called and they said use it .. yea when it throws the key my motor shaft takes a hit .THEN WHAT

It was easy to install, was packed very good. Came with everything I needed to bolt it up. Would recommend it to anyone

Excelent pump to much power I didn't spect that much power but its worth every single dolar

I knew this wasn't going to be the best pump. Most with specs like this will be at least $800. This pump lasted 4 washes. I've been washing for over 30 years and know how to properly treat a pump. Sorry i skimped.

Right on 3200psi at 5.5 tip orifice. Couldn’t be happier with Erie tools. Their name is etched on the pump Erie tools is a winner!!!

The pump i got has very poor power...it should be a beast @5.7 gpm