Canopy Fittings Kit 1-3/8" Low Peak Frame Carport Connectors – Full Set for 10 Legs, Heavy-Duty Galvanized Steel, Rust-Proof Finish

Good product, great price, Amazing seller!

Works perfect for a patio cover ..able to customize to the size you need..and should last for many years opposed to the pop up covers that last one or two years

I bought the Canopy Fittings Kit Low Peak Frame Carport Connectors 10 leg set. The Fittings work with 1-3/8" and 1-5/8" chainlink top rail. The 1-3/8" is a loose fit, but seems to work ok. If you run the 1-3/8" completly through a fitting, sometimes you will need to file the welds so the pipe will slide all the way through. The 1-5/8" fits perfectly over the outside of the fittings. In the picture where I point out the 1-5/8" pipe, look at the fitting. The pipe fits real nicely over the outside diamenter, of the fitting. The picture where the 1-3/8" pipe is labeled, the pipe goes continuously through the fitting. The 1-3/8" pipe does not have to go all the way through. I did this because I can with a liittle filing of the weld. The distance that both sizes of pipe either go over or inside the fitting is anywhere from 4-1/8" to 4-5/16" unless you are able to slide the pipe through if able. The pipe fittings measure 1.384" inside dia. The outside dia measures 1.515". The 1-3/8" top rail made by Everbuilt I used measures 1.3155" ID. The 1-5/8" top rail I used measures 1.532" ID and 1.6650" OD.

They are of good quality. Make sure you have the right size top rail pipe,i did not,hence only 3 stars caus they dont offer any kind of adapter

Made of ample gauge and quality of steel. Pre-drilled screw/rivet holes to hold it all together would be a HUGE plus. I pre-drilled the fittings and used self-tapping screws to secure the poles to the fittings after it was up. I was very impressed with the appearance and craftsmanship of the welds (didn't look like pigeon poop and had full even beads around every joint.) After much investigation and procrastination I decided to anchor it to the ground as shown in the plan sketch. I didn't pour the concrete in the holes until it was completely erected, which made aligning the vertical side poles ease. Just waiting for my tarp to arrive !! NOTE: Horizontal pipes between "B" 4-way fittings on sides and roof center line can slide through fitting, which saves quite a few pipe cuts. (I went with 16' deep so I only needed to cut (6) pipes to 8' length for the horizontal sides and roof peak.)

Terrible

It went together perfectly, hopefully it holds up well.

I purchased the canopy fitting to construct a home for my chickens. The fitting worked perfectly with 1 3/8-inch top rail. I did end up securing the fitting with self-tapping screws as I intend to move the structure around my property from time to time. If you are interested in making a structure that uses 1 3/8-inch top rail I would recommend using fittings of this type.