BEACON HOLD The Foam Glue For Styrofoam,White, 59ml

Excellent product, easy applicator and works perfectly to adhere foam

Does what I want and easy to use

I used this to glue open cell polyurethane foam to craft foam and the bond appears to be quite strong, though I'm not certain how durable it will be yet as the glue only just cured - but applying a little force to the glued seam gives me the impression that the open cell foam would tear before the glue itself let go. It does dry "clear", but reminds me of standard PVA glue in that it leaves an obvious, opaque glue dollop on the surface - easy to deal with though, just apply it sparingly so there isn't as much oozing out from the joint. I used a cheap paintbrush for this purpose and the brush washed clean easily and quickly with water and did not damage the brush. I should also note that this is not just PVA glue in a different branded package. I've used standard, white PVA glue on these types of foam before and it was nowhere near as strong and took several hours to dry - in contrast this glue dried within an hour. Standard PVA glue also saturated the open cell foam leaving it very stiff and unpliable. This glue remained on the surface of the open cell foam without penetrating it too deeply. Thus the surface became somewhat stiff, though not as stiff as standard PVA glue, but left the foam soft and mouldable throughout. Also, in response to a previous reviewer - on my tube of glue there was no hidden label underneath the one shown in the picture revealing a "Kids Choice Glue". Perhaps this buyers glue came from a different supplier.

Worked perfectly

This is very good for extra protection on your pinch hinge control surfaces on radio controlled aircraft. Just make sure that you have a very thin coat. If too much you're going to cause very bad issues with the moving. Adds years to your life without any damage. Strongly recommend