K90455 Suspension Stabilizer Bar Link for Honda Civic

I got these to replace my oem parts. I also purchased a separate kit for other front end suspension components. That kit had sway bar end links in it as well. The parts with the kit were much smaller, not as solid, and didn't include zerc fittings to add grease. After changing the entire front, I still had a slight clunking which was remedied by tightening up these a little bit. In general Moog has been known to make quality parts, but in this day and age you have to evaluate each part on its own. These however cleared the bar easily, controlling body roll much better than the oem, or some other aftermarket parts. Feels nice to have the body feel flatter around turns, esp in an suv

Used on 2nd gen CRV. Make sure you add grease before use. The supplied nut is a 15 mm and not the 14 mm from OEM. NOTE: this is specific to a location or side. Make sure only order one and then order the opposite corner. These are not interchangeable from side to side.

Moog is a great company, their products have a great reputation of reliability. They fit perfectly into my Honda CRV 2005, I would definitely recommend this product!

Not sure what sheerness means here. But this part fits my 03 civic. It's easily installed. Beefier than OEM. There's no instructions about orientation. It appears that the grease fittings could face either up, or down. Should've been instructions about that. And since these are replaced in pairs. Left and right should be marked somehow. I had to reference the number while in the middle of the filthy project. A simple marking on the box would've saved aggravation.

Make sure to replace your end links in pairs. This item is for your front RIGHT (K90455). For the front LEFT, it is K90454. If your car squeaks like crazy going over every small bump, it's probably your sway bar. First make sure your bushings are greased properly and have not worn down from contact with the bar. If your bushings are shot, then replace them with bushings that have grease zerk fittings such as Energy Suspension. They will last longer since they would be lubricated and you won't have to take it apart to grease. Next, check your sway bar end links. If the boots on your end links are ripped, then you need new end links. Right out of the box these end links are noticeable heavier and about 2x thicker so they can be used with larger aftermarket sway bars. They also have a large rubber boot that is already greased but can hold a lot more grease than my factory ones. These also come with grease zerk fittings so you can grease them instead of replacing them if the grease disappears over time. The end links also have a different installation system instead of your factory one that required a hex key and a crescent wrench. These use a regular nut and you just need something to hold the other end when installing. There are 0 chances of you stripping the end link which saves you a lot of trouble. I installed these on my 2003 Honda Civic Coupe.

Car had some creaking and clunking sounds while going over bumps and dips. Replaced both front end links, and now the car feels great with no more sounds. Installation is mid level, if you know the tricks to installing endlinks, it shouldn't take too long.

Perfect fit for 2005 Honda CR-V Front Right. What a HUGE ride improvement after these were replaced. Initially thought it was the struts that were worn since the Lower Control arm with compliance bushing were replaced with only marginal ride improvement. Worn compliance bushings definitely needed to be replaced. Glad the struts still have plenty of life in them. These bar links are beefier than the OEM. Very good Moog quality. Hope these last a very long time.

I had to use heat to release the old rusted on one, and that’s how I found out it had plastic in the joint. Disintegrated with minor pressure after the heat. Hopefully that was a cheap replacement by a prior owner (can’t be oem, right?). Anyway- not so with the moog part! All metal, very stout. Totally overkill for a little Honda civic by I love knowing this part will outlast the car. I’ll never have to replace it again.

Delivered on time and works perfectly. Very solid. Worth the extra money.

Used these on my d17a1 Honda civic 2002 LX Fits with an issue. And seems stronger then the oem. and cheaper. Got it replaced from a shop. The clunking noise have gone away.

Hi quality!

Moog makes suspension parts right!

Good replacement and easy to replace. Everything went well.